8/8/2019 07 08 Toyota Camry Grille Installation Manual Carid

1/3

http://www.carid.com/toyota-grill/http://www.carid.com/toyota-accessories/http://www.carid.com/

8/8/2019 07 08 Toyota Camry Grille Installation Manual Carid

2/3

2 Copyright 2006 by E&G Classics, Inc.

6. Before installing the upper grille, align the lowermesh section onto the lower frame.7. Trim the ends from the supplied silicone sleevesand install a sleeve onto each lower mounting stud(all locations).

8. Use wide masking tape to tape up the lower grilleopening. Carefully insert the lower mesh and frameinto the factory lower grille opening and install a1 O.D. by 1/8 I.D. black plastic washer onto eachmounting stud and install an 8-32 ESNA half nut(as shown) and tighten (LE & XLE shown, SE instal-lation procedure is the same.

9. Use wide masking tape to tape upto the inneredge of the upper grille mounting studs and applyflat or semi-gloss black paint to conseal them. Also

tape across the top face of the grille andpaint the top and sides of all six (6)upper mounting tabs ( not shown) to conseal

10. Use masking tape to tape around the factory grilleopening 1/2 inside from the face of the bumpercover. Use flat or semi-gloss black paint and paint

everything inside the taped factory grille openingthat would be visible through the mesh grille,including across the top of the grille opening.

11. Carefully align the studs through the factory grillemounting slots, making sure you do not damageor scratch the factory paint around the grille open-

ing.

8

9

8

7

5

5. Continue pulling out on the grille until it complete-ly unclips from the bumper cover.

Car Accessories | Toyota Accessories | Toyota Grilles

http://www.carid.com/toyota-grill/http://www.carid.com/toyota-accessories/http://www.carid.com/

8/8/2019 07 08 Toyota Camry Grille Installation Manual Carid

3/3