two-wire rtd temperature transmitter
DESCRIPTION
The initial offering in Acromag's new ST130 series of low-cost, temperature transmitters is an ASIC-driven RTD signal conditioner, Model ST131. Units combine the simplicity of a digital USB setup and calibration interface with the inherent performance advantages of analog signal conditioning. Selling for just $89 with free Windows configuration software, this DIN Form B head-mount instrument will convert the input signal from any 100 ohm Platinum RTD sensor to a highly accurate, loop-powered 4-20mA output. A ruggedized design features -40 to 80°C operation, electrical noise immunity, and surge protection.TRANSCRIPT
ST131 RTD Transmitter
Product Presentation
Agenda
1. ST131 Introduction 1. ST131 Introduction
2. Key Features & Benefits 2. Key Features & Benefits
3. Target Markets 3. Target Markets
4. How To Use 4. How To Use
5. How To Order 5. How To Order
6. Where to Find More Information6. Where to Find More Information
ST131 RTD 2-Wire Transmitter
Key Features & Benefits
• USB Configuration & Calibration• Advanced Analog ASIC inside• Highly accurate/low drift• Fast Response• Programmable Over/Under Range• Programmable Up/Down Fault levels• Wide Operating Temperature -40 to 80C• Designed for CE, UL/cUL CL1Div2 (Zone 2)• Designed/Manufactured to AS9100 and ISO9001
Target Markets/Users
• OEM’s– Sensor Mfg’s/Packagers– Boilers, Furnace, HVAC– Semiconductor Equipment – Machine/Equipment Builders
• End Users– Power Generation– Water/Wastewater– Oil/Gas– Chemical/Petrochemical– Refineries– Food/Dairy/Beverage– Pharmaceutical– Building Automation/HVAC– Military/Defense/Aerospace– Test & Measurement/R&D
How to Use – Step 1 of 2 (wiring)
How to Use – Step 2 of 2
Configure
Calibrate(follow wizard instructions)
How to Use – Step 3 of 3
Set URV
Set ORV
Set Fault Detect
Validate data-points w/ simulator and you’re Ready to Install!
How To Order
• Xmitters • Mountings • ST13C Kit
How To Order – Model #’s
• Select Transmitter– ST131-0600 (CE)– ST131-0600-C– ST131-0610 (Zone 2)– ST131-0610-C
• Select Mounting– ST130-MTG
– ST130-DIN
– Ex Proof or General Purpose Enclosure
(4001-115,6,7 & 9)
• Specify one or both:– 1pc Model ST13C-SIP (recommended per customer)– Order Factory Cal (-C option) for Quick Startup
• Input: -50 to +50C, 100ohm Pt,3-wire, upscale break• Output: 4-20mA
For More Information
• Go to www.acromag.com and search on ST131
• To contact Acromag or find your local Representative or Distributor:– Email: [email protected]– Tel. 248-295-0880– Fax 248-624-9234