Single Stage Vane Separator

The Seaworth Single Stage Separator system is designed to eliminate moisture ingress where space restrictions indicate the need for high velocity and large water volumes are evident.

Construction:

The Seaworth Vane Separator units are constructed in aluminium with anodised vanes and powder coated casing. The units are robustly constructed and are suitable for a harsh marine environment. The Seaworth Separator unit will operate up to 6.1m/sec with a normal design velocity of 5.0m/sec.

Seaworth Single Stage Separators are included on Z-Tech Tug “FARFAN”: Photo courtesy of Cheoy Lee Shipyard Ltd

Vane Separator:

The Single Stage separator achieves maximum possible water loading with minimal weight and pressure losses. Air drawn through a series of specially designed vanes which trap water, which then drains verti-cally down to the drainage channel and finally out the front drain slot or into a Manometric drain trap.

Front and Rear flange options are available depending on project requirements. Contact Camfil NZ for details on options available.

Mounting: Seaworth Separator units are supplied with predrilled flange, 316 st/st countersunk screws, nylon insulators and neoprene flange gasket.

Sizing Information Height Width Vessels Opening H W Over Flanges H + 60mm W + 60mm

Open Face Size H - 130mm W - 60mm

Overall Depth: 75mm

This data is guideline only and is subject to change. For further information please contact Camfil New Zealand Ltd

www.seaworth.com

Manufactured By: Camfil New Zealand Ltd

PO Box 531, Albert Street Cambridge, New Zealand

NZCB-Sales@camfil.com PH: +64 7 827 4142

Performance

Water Handling 24 Ltr/min per mtr Capacity width

Maximum Face 6.5m/sec Velocity VTT Expert Services Tested at 5.0m/sec

Rated "A" (100%)