2-stage vane separator - seaworth sheet 2 stage.pdf · 2-stage vane separator the seaworth 2-stage...
TRANSCRIPT
2-Stage Vane Separator The Seaworth 2-Stage Separator system is designed for opera-tion in harsh marine environments. It is used on Off-Shore Platforms, air intakes on marine vessels and Coastal air intake where salt is an issue. The coalescer is also a G3 rated dust filter.
Two Configurations for this item are available:
(1) Vane Separator followed by Filter/Coalescer—Velocities up to 4.5m/sec.
(2) Filter Coalescer followed by Vane Section—Velocities up to 6.1m/sec
Seaworth 2-Stage Separators are included on the Cape Class Patrol Boats: Photo courtesy of Austal
Photo courtesy of Q-West & Skipper Magazine
GT2 Coalescer Panel:
Consists of a special polymer media sand-wiched between stainless steel welded wire mesh. This structure is corrugated and retained in a 316 stainless steel housing. The GT2 reduces airborne salt spray and dust contaminants down to usual design requirements. Using the Sea-worth HV2 bag or HE10 can increase salt effi-ciency to 0.0013ppm against the NGTE 30 knot aerosol.
Vane Separator:
Constructed of marine grade anodized alumini-um, the marine separator achieves maximum possible water loading with minimal weight and pressure losses. Air drawn through a series of specially designed vanes which trap water, which then drains vertically down to the drain-age channel and finally out the front drain slot or into a Manometric drain trap.
Sizing Information Width Height
Vessels Opening W H
Over Flanges W + 60mm H + 60mm
Open Face Size W - 60mm H - 130mm
Overall Depth: 110mm
This data is guideline only and is subject to change. For further information please contact Camfil New Zealand Ltd
www.seaworth.com
Manufactured By: Camfil New Zealand Ltd
PO Box 531, Albert Street Cambridge, New Zealand
[email protected] PH: +64 7 827 4142
Performance
Water Handling 24 Ltr/min per mtr Capacity width Maximum Face 6.5m/sec Velocity
VTT Expert Services Tested at 5.0m/sec
Rated "A" (100%)
Efficiency with GT2 or PB1 Coalescers
0.01ppm against NGTE - 30 knot aerosol
Mounting:
Seaworth Separator units are supplied with predrilled flange, 316 st/st countersunk screws, nylon insulators and neoprene flange gasket.