pag. k00398 grinding silver sp-211 - hispana maquinaria · pag. k00398 caracteristicas...
TRANSCRIPT
PAG. K00398
CARACTERISTICAS CHARACTERISTICSPotencia instalada Power installed W. 1450Peso aprox. Aprox. Weight kgs. 90Peso dotacion productos incial Weight of products to start kgs. 60Medidas sin cuba enjuague Sizes w/o rinsing tank cms. 88,5x58,5x65,5Medidas con cuba enjuague Sizes with rinsing tank cms. 88,5x72x65,5Medidas embalaje Packing sizes cms. -
JUST CAST
2ndSTEP
1stSTEP
JUST CAST
1stSTEP
2ndSTEP
SILVER
GRINDING
SP-211POLISHING
SP-211 (2nd SILVER STEP) is a different machine, uses different compound, makes different work than PMG (1st SILVER STEP). PMG give better resaults in the outsides.
SP-211 2nd SILVER STEP REACHES RECESSED AREAS, INSIDES, FILIGREE AND JEWELS WITH STONES CAST IN PLACE.Does not affect stones, enamelling, and non conductive surfaces.
SP-211 makes now in a few minutes the MOST DIFFI-CULT WORK in finishing process, impossible for other automatic or mass processes, and very difficult and costly to do by hand. Easy. Automatic.
SP-211 makes your design much more free, since does not round prongs or angles and follows most accurately the contour of your design.
SP-211 can process practically all pieces normal in jewellery, even colliers or chains, enabling to process very heavy and very light pieces, at the same time.
SP-211 will: INCREASE your production, INCREASE your quality DECREASE your cost DECREASE your metal loss
RECOVERY THE METAL REMOVED - All metal removed will remain in the machine.
SILVER2ND STEP
BRASS
Tel. +34 93 3091707 Fax. + 34 93 3090702 e-mail: [email protected]
internet: http://www.hispanaspain.com C/ Can Cuiàs, 24-26 - Pol.Ind. Can Cuiàs, nave 20/1
Montcada i Reixac 08110 - Barcelona - España (Spain)
HISPANAde Maquinaria, S.A.
PAG. K00398d
1st STEP
PROCESS ON INSIDES, REACHES RECESSED AREAS, FILIGREE AND JEWELS WITH STONES CAST IN PLACE.
1 minuto - minute
PROCESS ON OPEN SURFACES
30 minutos - minutes
2nd STEP
SP211 PROCESS - SILVER - STEPS
Stamping
SP211 (2nd Step)
Very light buffing
Drying
Ultrasonds
Short buffing
GP10 - 50 min(1st Step)
Careful selectivegrinding
GP5 min.
Casting
Tel. +34 93 3091707 Fax. + 34 93 3090702 e-mail: [email protected]
internet: http://www.hispanaspain.com C/ Can Cuiàs, 24-26 - Pol.Ind. Can Cuiàs, nave 20/1
Montcada i Reixac 08110 - Barcelona - España (Spain)
HISPANAde Maquinaria, S.A.