x431pro actual measurement 2010 buick new lacrosse the...
TRANSCRIPT
【X431PRO Actual Measurement】2010 Buick new lacrosse the steering angle sensor learning operation method.
Actual Measurement car model:new lacrosse,2010,VIN=LSGGF59B1AH0*****, See pic1。 pic1
Error info: Dashboard display wrench,Prompt “overhaul ESP”. After enter into ESP system,Read 6 error code:U0073 communication Bus line A control module closed;U0100 lost communication with engine control module; U0140 lost communication with car body control module;U0125 lost communication with multi-axis acceleration sensor module;C0242 Power system module display traction control;C0710 6/5000 Steering position signal,see pic 2。
pic5
6.System Selection; 7.Select Electronic Brake control module, see pic6;
Electronic Brake Control Module
pic7
9. Select Electronic Brake control module version according to vehicle configuration, see pic8;
pic8
10.Select config /reset,The learning function of the steering wheel Angle sensor is usually in
the configuration/reset function,see pic9;
Config/Reset
pic10
12. Follow the instructions to set the correct direction so that the front wheel of the vehicle is
facing forward and the steering wheel is centered ,click”confirm”,see pic11;
pic11
13.Click Confirm,The steering wheel Angle sensor learning function begins,send instructions。The function data flow condition is: the vehicle stops, the place It has a wheel speed of 0,see pic12
Pic 12
14. After satisfying all conditions,waiting for 5~10s,prompt function execution is
finshed.see pic13,Then switch off the ignition.
pic13
15.Switch on the ignition, check the dashboard prompt info,The original display information has disappeared,see pic14。Re-enter into electronic brake control module, clear error code,
then do verification when running the car, if everything is normal ,the error is solved.。 see pic14.