x431pro actual measurement headlight correction operation ... · replace hid headlights any...
TRANSCRIPT
【X431Pro Actual Measurement】2013 Ford S-MAX
Headlight correction operation method.
Actual Measurement: Ford S-MAX,2013,VIN=WFOSXXGBWSDB*****
Note:
1. Equipped with headlight control system; 2. Keep static at the level ground; 3. Keep the battery voltage adequate ; 4. The steering wheel has always been upright; 5. Don't sit in the car; 6.Keep no-load.
Operation Procedure
1. Select China Ford V45.20 above; 2. Select auto-search; 3. Select System selection; 4. Select HCM(Headlight-Control System); 5. Select(Headlight calibration,see pic1;)
pic1
6. Note the items, as shown in figure 2 "the new alignment setting will be stored. Replace HID headlights Any component in the system should be tested. Perform this function to set new calibration values In the module, this test is performed when any component in the headlamp system is replaced.
pic2
7. System Prompt:Switch on the ignition. Be ready to start calibrate. See pic3;
pic3
8.Vehicle status verification, as shown in FIG. 4: vehicle on horizontal ground; The steering wheel keeps moving forward Buy; If the vehicle has headlamp level control, set the value to 0; There are no heavy objects on the vehicle.。
pic4
9. System prompts to turn on the near light; 10. Manual correction, the prompt information is shown in figure 5: using appropriate lighting adjustment equipment, Adjust the left and right headlights to the correct alignment, then proceed to the next step;
pic5
11. System prompt: the program guides correct correction of the correct school and the program executes successfully; 12. System tip: turn off the headlamp; 13. Hit the switch to OFF and the calibration successfully completed, as shown in figure 6.
pic6