vertical tail design

9
Vertical tail design and Spiral Stability Vertical tail design Central of lateral area Inertial roll coupling Locating the CLA Vertical tail aspect ratio Dorsal fins All –moving horizontal T-tails Rudder power Rudder aileron effect Spiral stability Levels of spiral stability Lateral and directional coupling Balance of forces Spiral stability margin

Upload: trilochan-kumbhkar

Post on 19-Jul-2015

40 views

Category:

Design


0 download

TRANSCRIPT

Page 1: vertical tail design

Vertical tail design and Spiral Stability

Vertical tail designCentral of lateral area Inertial roll coupling Locating the CLA Vertical tail aspect ratio Dorsal fins All –moving horizontal T-tailsRudder power Rudder aileron effect Spiral stability Levels of spiral stability Lateral and directional coupling Balance of forcesSpiral stability margin

Page 2: vertical tail design

Verticlal Tail Design

Wing dihedralFuselageLanding gear side areasCG location Tail areaRudder

CLA (spiral stable)-25% of TMA aft CG-a line through CLA & CG horizontal-the wing joining the front CLA &rear CLA sloped

upward to the front -

Page 3: vertical tail design

Inertial roll coupling

Aerodynamic axis & inertia axis aligned –no inertial coupling.

Rotation abt aerodynamic axis will create CF.

CFs produce pitching moment

Page 4: vertical tail design

Dihedral

sweepback 2 to 3 deg. equivalent to 1deg. Dihedral High wing-2Mid wing -3 Low wing -4

Locate CLA Profile of designSettle to 25% of TMA to get good VTLeft right lateral surface due to dihedral

Page 5: vertical tail design

-large VT area with no dihedral angle leads to sideslipLarge tail resist slip

Page 6: vertical tail design

Vertical aspect ratio -ARv=1.55*Bv^2/Sv

Dorsal fin

-Increase fuselage stability at high speed angle

-Reduce VT stalling

Rudder power

-Area 30% of VT

-Rudder aileron effect –reduce aileron efffect ( forced yaw)

-Rudder area center above horizontal tail line through CG will act as aileron

Page 7: vertical tail design

Spiral Stability

-Degree of spiral stability -Spirally stable -neutrally spirally stable-spirally unstable-angle of bank slowly increases ,speed gradually increases-for sailplanes good SS, sport model moderate , aerobatic models neutral

Page 8: vertical tail design

Lateral & directional coupling

SS requires a balance between lateral and directional forcesDutch roll--large dihedral angle with small VT lateral forces are high wagging coupled with a slight side to side roll

Balance of forces –Lateral &directional forcesLS-Dihedral , angle of sweep back , Cl , AoAForward sweepback- destabilizes , increases yaw-VT area prevents yaw-advantage -wing stall at root first

Page 9: vertical tail design

DS-

-Dorsal fin-to overcome a lack of VT effectiveness flaps extended & high side slip

-Sweepback- aids DS

- Drag moment reduces yaw

Aileron eliminate aileron induced adverse yaw

-SSM 25% of VTMA

-CG moved aft of the wing SSM VTMA decrease