steps to repurposing collar 2 (1)
TRANSCRIPT
Steps to repurposing: Paracord/Rope
What you will need:
Supplies
1.Paracord or thin rope2.Buckle3.Jump ring or D-ring4.Lighter5.Scissors6.Tape measurer/ruler
Measure your dogs current collar or simply measure around their neck
1
For every inch of collar you need one foot of rope. So for my dogs 12 inch collar, I will need to measure and cut two strands of 12 foot string
2
If your using paracord, burn the ends of the cord to prevent fraying
3
Step 4: Weaving process
1.
2. 3.
4. 5. 6.
7. 8. 9.
Weaving Process…
1. Take a strand of your cord and fold it together, making sure the ends are even. Put the folded side into the female part of your buckle and take the ends of the cord and pull it through (do this to the other piece of cord/rope also).2. Separate your middle strands from your outer strands.3. Start with one of your OUTER strands and go over the MIDDLE strands and UNDER the other OUTER strand.4.Pull the string through the loop you have just made.5.Pull tight.6.Pull tight.7.Repeat8.Repeat9.Repeat10. DO NOT weave all the bracelet yet, stop where you would like to add your jump ring and your dog’s tags.
5
Add your jump ring with your dogs tag attached and simply continue your weaving process.