nsclient++ workshop: 02 web
TRANSCRIPT
monitoring
Web
Enabling: WEB Interface
2:1 Enable WEB UI
You know this one by now…
Enable the WEB UI
Set the password to: kjYhD#”!&rsK98D3fG5rwREddf##¤%!”åäöÅÄÖ
Enable the WEB UI
Set the password to: kjYhD#”!&rsK98D3fG5rwREddf##¤%!”åäöÅÄÖ
nscp help
Enable the WEB UI
Set the password to: kjYhD#”!&rsK98D3fG5rwREddf##¤%!”åäöÅÄÖ
nscp help
nscp web help
nscp web [???] help
Enable the WEB UI
Set the password to: kjYhD#”!&rsK98D3fG5rwREddf##¤%!”åäöÅÄÖ
nscp help
nscp web install
nscp web password –set kjYhD#”!&rsK98D3fG5rwREddf##¤%!”åäöÅÄÖ
Using the WEB Interface
2:1 Use the WEBUI
http://localhost:8080
https://localhost:8443
The password you set last assignment
Load and configure NRPE on port 6161
Load and configure NRPE on port 6161
Use the modules tab
And dont forget to save the settings, and restart
Load and configure NRPE on port 6161
Click: Modules, NRPEServer
Click: Load, Configure Tab, Change the port to 6161 and click ”Save Settings”.
Notice that this change is only ”in memory” so you need to click ”save” as well on the settings tab.
Finally restart nsclient++