mitel to nokia e71

Upload: chris-mcandrew

Post on 30-May-2018

226 views

Category:

Documents


0 download

TRANSCRIPT

  • 8/9/2019 Mitel to Nokia E71

    1/12

    Configure the Mitel 3300 ICP for use with the Nokia E71 Mobile Phone

  • 8/9/2019 Mitel to Nokia E71

    2/12

    Table of Contents

    Overview .............................................................................................................................................3

    Software & Hardware Setup .......................................................................................................3

    Device Limitations ..........................................................................................................................3

    3300 Setup Notes ............................................................................................................................4

    Network Requirements .......................................................................................................................................... 4

    Assumptions for the 3300 ICP programming .............................................................................................. 4

    Licensing and Option Selection - SIP Licensing ........................................................................................ 5

    Multiline IP Set Configuration............................................................................................................................. 6

    Class of Service Assignment .............................................................................................................................. 7

    SIP Device Capabilities Assignment ............................................................................................................... 9

    Station Service Assignment .............................................................................................................................. 10

    Multiline Set Key Assignment........................................................................................................................... 11

    Nokia E71 Mobile Phone Setup Notes..................................................................................12

  • 8/9/2019 Mitel to Nokia E71

    3/12

    Overview

    This document provides a reference for configuring the Mitel 3300 ICP to host the Nokia E71 Mobile Phone. The

    different devices can be configured in various configurations depending on your VoIP solution. This document

    covers a basic setup with required option setup.

    Software & Hardware Setup

    This was the test setup to generate a basic SIP call between the Nokia E71 Mobile Phone SIP device and the 3300

    ICP.

    Manufacturer Variant Software Version

    Mitel 3300 ICP MXe platform 9.0.1.20

    Nokia Nokia E71 Mobile Phone 110.07.127 (09-10-2008)

    Device Limitations

    This is a list of problems or not supported features when the Nokia E71 Mobile Phone is connected to the Mitel

    3300.

    Feature Problem Description

    MWI Nokia E71 does not support MWI

    Conference Nokia E71 does not support device-based conference

    Call Forwarding Nokia E71 does not support device-based call forwarding

    Call hold There is no music played on Nokia E71

    Teleworker Nokia does not register and thus does not work with Teleworker

  • 8/9/2019 Mitel to Nokia E71

    4/12

    3300 Setup Notes

    The following steps show how to program a 3300 ICP to connect with the Nokia E71 Mobile Phone.

    Network Requirements

    There must be adequate bandwidth to support the voice over IP. As a guide, the Ethernet bandwidth isapprox 85 Kb/s per G.711 voice session and 29 Kb/s per G.729 voice session (assumes 20ms

    packetisation). As an example, for 20 simultaneous SIP sessions, the Ethernet bandwidth consumption will

    be approx 1.7 Mb/s for G.711 and 0.6Mb/s. Almost all Enterprise LAN networks can support this level of

    traffic without any special engineering. Please refer to the 3300 Engineering guidelines for further

    information.

    For high quality voice, the network connectivity must support a voice-quality grade of service (packet loss

  • 8/9/2019 Mitel to Nokia E71

    5/12

    Licensing and Option Selection - SIP Licensing

    Ensure that the 3300 ICP is equipped with enough SIP Device licences for the connection of SIP end points. This

    can be verified within the License and Option Selection form.

    Figure 1 License and Option Selection

  • 8/9/2019 Mitel to Nokia E71

    6/12

    Multiline IP Set Configuration

    On the Mitel 3300 ICP, a SIP device can be programmed either in the User Configuration form or the Multiline IP

    Set Configuration form and are programmed as a Generic SIP Phone. Enterprise Manager can also be used to

    provision where this application is installed.

    The Login PIN is the SIP authentication password and the username is the DN. The Number and Login PIN must

    match the information in the Nokia E71 Mobile Phone configuration. All other field names should be programmed

    according to the site requirements or left at default.

    Figure 2 Multiline IP Set Configuration

  • 8/9/2019 Mitel to Nokia E71

    7/12

    Class of Service Assignment

    The Class of Service Options Assignment form is used to create or edit a Class of Service and specify its options.

    Classes of Service, identified by Class of Service numbers, are referenced by the Station Service Assignment form

    for the SIP devices.

    Figure 3 Class of Service Assignment

  • 8/9/2019 Mitel to Nokia E71

    8/12

    Figure 4 Class of Service Assignment (Cont)

  • 8/9/2019 Mitel to Nokia E71

    9/12

    SIP Device Capabilities Assignment

    This form provides configuration options that can be applied to various types of SIP devices. The association

    between the SIP device and the form is similar to how the Class of Service options work. The SIP Device

    Capabilities number provides a SIP profile that can be applied to particular SIP devices to allow for alternate

    capabilities as recommended through the Mitel interop process.

    In the Device Capabilities form, program a SIP Device Capabilities Number for the Nokia E71 Mobile Phone

    device. Ensure that Replace System based with Device based In-Call Feature is set to Yes.

    For call hold, Prevent the use of IP Address 0.0.0.0 in SDP Messages and Force sending SDP in initial Invite

    message have to be enabled.

    Figure 5 SIP Device Capabilities Assignment

  • 8/9/2019 Mitel to Nokia E71

    10/12

    Station Service Assignment

    Use the Station Service Assignment form to assign the previously configured Class of Service and SIP Device

    Capability number to each of the Nokia E71 Mobile Phones in the 3300.

    Select the Nokia E71 Mobile Phone device number then select Change. Enter the previously configured SIP DeviceCapability number and Class of Service for Day, Night 1 & Night 2.

    Figure 6 Station Service Assignment

  • 8/9/2019 Mitel to Nokia E71

    11/12

    Multiline Set Key Assignment

    You use the Multiline Set Key Assignment form to assign the line type, ring type, and directory number to each line

    selected on the Nokia E71 Mobile Phone device.

    Figure 7 Multiline Set Key Assignment Form

  • 8/9/2019 Mitel to Nokia E71

    12/12

    Nokia E71 Mobile Phone Setup Notes

    The following steps show how to program the Nokia E71 Mobile Phone to interconnect with the 3300 ICP.

    1. SIP Settings

    On Nokia E71 Mobile phone: Menu ToolSettingsConnectionSIP Settings

    A). Main Settings

    Profile Name: 3211

    Service profile: IETF

    Default access point: Connection2 (Access Point)

    Public user name: [email protected] (Extension Number @3300ICP_IP_address)

    Use compression: No

    Registration: Always on (When needed is deregistration)

    Use security: No

    B). Proxy Server Settings

    Proxy server address: 192.168.101.10 (3300 ICP address)

    Realm: sipint1 (Need to be 3300 name configured in Network Element assignment)

    User name: 3211

    Password: SIP Password. It must match the one in 3300ICP

    Allow loose routing: Yes

    Transport type: UDP

    Port: 5060

    C). Registrar Server Settings

    Registrar server address: 192.168.101.10 (3300 ICP address)

    Realm: sipint1 (Need to be 3300 name configured in Network Element assignment)

    User name: 3211Password: SIP Password. It must match the one in 3300ICP

    Transport type: UDP

    Port: 5060

    2. Internet Telephone (net call setting): Menu ToolSettingsConnectionInternet tel.

    Assigning SIP Profile to Internet Telephone (net call setting)

    Name: 3211

    SIP Profiles: 3211

    3. Communication: MenuCommunic.Internet tel.

    Select Connection2 and Press Option to change service, selecting net call service (3211) from the list.

    4. Registration

    Registration: Selecting Always on, the phone will be registered.

    Selecting When needed, the phone will be deregistered.