Harding High School

Technology Lab Safety Power Machine Review

Mr. Pottkotter & Mr. Robinson

Table Saw

ON/ OFF

BUTTONS

MITER GUIDE GROOVE

BLADE

GUARD FENCE

BLADE HIEGHT ADJUSTMENT WHEEL

BLADE ANGLE ADJUSTMENT WHEEL

TABLE

Table Saw

• Always use the _________ when ripping a piece of stock.– Fence

• If the stock _________, hold it down tight and turn the saw off.– Pinches

Table Saw

• Always ________ until the blade stops moving before removing any stock from any machine.– Wait

• Use the ________ when crosscutting a piece of stock.– Miter Guide

• Always use the _______ when ripping a piece of stock.– Fence

Band Saw

On/ Off ButtonBlade

Table

Blade Guard/Guide

Scroll Saw

On/ Off

Table

Hold Down Clamp

Ban Saw

• If the _______________, turn off the machine and tell the instructor.– Blade Breaks

• Use ___________ when making sharp curve cuts.– Relief Cuts

Ban Saw

• Always keep a _______ safety margin between your fingers and the blade.– 3”

• Never adjust the _______ when the machine is running.– Guard

SurfacePlaner

Thickness AdjustmentWheel/ Guide

Thickness Gauge

On/ Off Buttons

Cutter Head (Inside)

Feed Rollers

Infeed Table

Surface Planer

• This machine cuts the _______ side of the stock.– Top

• Let the machine reach ____________ before putting the stock in.– Full Speed

• Keep _______ back so they are not pinched between the stock and the table.– Fingers

JointerOutfeed Table Guard

Infeed Table

Fence

Infeed TableAdjustmentWheel

Jointer

• Never _____ when the machine is running.– Leave

• Never stand directly ________ the stock when using this machine.– Behind

• You use this machine to smooth and straighten ______ edge of a piece of stock.– One

Jointer

• Use a _______ when working with a small piece of stock.– Push Stick

• Never run the stock ______ the grain on this machine.– Against or Across

• Always keep the stock ______ against the fence.– Tight

Radial Arm Saw

Guard

Table

On/ Off

Buttons

Yoke

Fence

Radial Arm Saw

• Always return the saw to the ______ of the table after each cut.– Rear

• Always hold the stock tight against the _____ when using this machine.– Fence

• Never _____ the saw when the blade is moving.– Leave

Radial Arm Saw

• Hold onto the saw when ______ to prevent the blade from moving forward.– Starting

• The blade should extend ______ into the table.– 1/8”

Compound Miter Saw

Turntable

Handle

Guard

Fence

Table Top

Side Handle

Compound Miter Saw

• Always keep all ______________ in place.

• You should keep your hands and fingers at least how far from the saws path?

Guard

4 inches

Compound Miter Saw

• Let the saw reach full _______________ before you begin cutting your piece.

• You always want to secure your work piece to the fence or table using _________.

Speed

Clamps

Drill Press

On/ Off Buttons

Spindle Adjustment

Lever

Table

Column

Chuck

Table Lock

Drill Press

• Always ______ the wood to the table of this machine.– Clamp

• This machine can be used to ______ or _____ wood.– Drill or Sand

Drill Press

• Always remove the _______ after tightening or loosening the jaws.– Chuck Key

• Always keep hair, loose jewelry, and loose clothes away from what part of the machine above.– Chuck