Tuhd

90WWW.Rusch.Toa higheR level

Working-range diagram

TUHd-90 WiTH 5-Ton. Tool

Rated tipping load: 75% of the static tipping load (ISO 10567)

Total mass 240 ton.

Working-range diagram

TUHd-90 WiTH 10-Ton.Tool

Rated tipping load 75% of the static tipping load (ISO 10567)

Total mass 240 ton.

SaFeTY

The machine is equipped with 6 cameras. Two on the back of the

machine, one at the fore boom for an over view, one at the auxili-

ary stick looking at the tool and two looking inside the telescopic

boom to see if everything goes right (see photo). The crane is also

equipped with a safety system equivalent to a mobile crane. All

pressures of the hydraulical system can be seen, all angles of the

boom and sticks and the complete configuration of the boom.

When approaching a dangerous situation an orange lamp will

indicate 90% danger level reached. When 100% is reached the

movement will stop and a red light will come on. The machine can

only go back to a safe position before continuing. On the display

(see photo) you can see:

• Max. pressure in hydraulic

system

• Working Height

• Radius

• Angles

• Inclination of the machine

• 90 and 100% warning light

• Time

• Present program

A manual emergency system

is available in case this system

should malfunction.

10

20

30

40

50

60

70

80

90

10203040

66°

75°

81°85

°

90

80

70

60

50

40

30

20

10

40 30 20 10

66°75

°81

°85°

TUHD-90 Transportation module dimensionsDescription Max. Length Max. Height Max. Width Mass

(mm) (mm) (mm) (ton)Single track (total of 2) 9393 1655 1110 25.75Single track expansion (total of 2) 5410 1035 898 4Chassis, carbody, topcylinders and cabin 13530 4031 3933 66.3Original counterweight 3485 2560 850 16.8Extra counterweight 3507 2560 550 30 TOTAL MASS BOOM EX. TOOL: 70T

ThE TUhD-90 iS TrAnSpOrTED wiTh 7 LOw LOADErS.

This is divided in:

• Main body and Main booM cylinders

• counterweight of 28t

• counterweight 17t

• side beaMs and tools

• left track

• right track

• coMplete booM

The body is equipped with 4 cylinder to jack itself from the low

loader. In this position it is possible to connect the side beams

and tracks by means of a mobile crane. The cylinders are retracted

and the crane is standing on the tracks. Now both the 28T and

17T ballast blocks can be lifted in. The crane is now ready to take

the boom.