a10a startup rev001 - forums.eagle.ru

2GvSAP A-10A FM-A10A-CL

09/14/2009 of 15 Revision 001

The Second Guards Smeshannyy Aviatsionnyy Polk

present the

Operator's Checklist for

DCS A-10A

2GvSAP A-10A FM-A10C-CL

GENERAL COCKPIT FLOW

09/10/2009 of 15 Revision 001


1 External stores configuration Correct

2 Area Clear

3 Ejection seat SAFE

LEFT CONSOLE

1 IFF Antenna BOTH

2 UHF Antenna As required

3 Radar beacon OFF

4 CTVS/AVTR control panel OFF

5 KY-28/KY-58 OFF/set

6 Intercom control panel Set

7 VHF/FM control panel OFF/set

8 UHF control panel ON/set

9 VHF/AM control panel OFF/set

10 Emergency flight Control Panel Set

a. Flap emergency retract OFF

b. Flight control mode NORM

c. Aileron emergency disengage OFF

d. Elevator emergency disengage OFF

e. Speed brake emergecny retract OFF

f. Pitch/roll trim override OFF

11 TV monitor power OFF

COCKPIT INTERIOR CHECK (1 of 4)

09/10/2009 of 15 Revision 001


LEFT CONSOLE (cont.)

12 IFF OFF/set

13 HARS/SAS override NORM

14 Refuel status and indexer lights Set

15 Weapon station status lights Set

16 Master exterior lights Set

17 Throttles OFF

18 Flap level Set

19 Speed brake control Set

20 APU OFF

21 Engine operate switches NORM

22 Engine fuel switches NORM

23 Fuel system control panel Set

a. Main boost pump switches (L and R) MAIN

b. Wing boost pump switches (L and R) WING

c. Main fill disable switches (L and R) Press

d. Wing fill disable switches (L and R) Press

e. Air refuel control CLOSE

f. Tank gate CLOSE

g. Crossfeed OFF

h. External tank (WING and FUS) OFF

i. Signal amplifier NORM

24 Emergency brake handle IN (OUT if starting Right eng. first)


09/10/2009 of 15 Revision 001


INSTRUMENT PANEL

1 Landing gear handle DOWN

2 Landing/taxi light OFF

3 Armament Control Panel Set

a. Master Arm SAFE

b. EO PWR OFF

c. Gun rate SAFE

d. Electric fuzing SAFE

e. AIM-9 mode OFF

f. Release mode selective jettison OFF

g. Mechanical fuzing SAFE

h. Store loading display Check

i. Weapon station select switches Deselected

4 Clock Set

5 HUD mode selector OFF

6 Standby ADI CAGE

7 Accelerometer Reset

8 Fire handles In

9 Fire extinguisher discharge switch Center

10 Standby compass Check

11 Aux landing gear extension handle In

12 Circuit breakers Closed


09/10/2009 of 15 Revision 001


RIGHT CONSOLE

1 Electrical power control panel Set

a. APU generator OFF/RESET

b. Inverter OFF

c. AC generator switches PWR (L and R)

d. Battery OFF

e. Emergency flood light switch As required

2 ECM OFF

3 ILS control panel OFF/set

4 CDU OFF/set

5 Chaff/flare control panel Set

a. Flare jettison switch SAFE

b. Chaff mode OFF

c. Flare mode OFF

6 Environment control panel Set

a. Windshield defog/deice OFF

b. Canopy defog OFF

c. Rain removal OFF

d. Pitot heat OFF

e. Bleed air BLEED AIR

f. Main air SUPPLY

g. Temperature/pressure control NORM

h. Flow level control As required

i. Air conditioner control OPER AUTO

j. Temperature level control As required

7 TACAN control panel OFF/set

8 Lighting control panel Set

9 HARS control panel Set


09/10/2009 of 15 Revision 001


1 Area Clear

2 Battery PWR

3 Inverter STBY

Verify: INST INV, L/R ENG HOT lights OFF

ITT < 150°C, OFF flag not visible

4 Fire detect/bleed aire leak test Perform

5 Gear lights Check

6 Signal lights Test

7 Fuel quantity Check

a. Test indicator button PressVerify: Reads 3000 lbs (L and R) and 6000 lbs total

b. Fuel display Check each position, reset to MAIN

8 Oxygen quantity Check

Verify: OXY LOW light OFF

a. OXY IND TEST button PressVerify: OXY LOW light ON at 0.5 liter

9 APU switch START

Verify: L-FUEL PRESS light OFF

CAUTION:! If unable to start APU via onboard battery, may be unable to restart engines in flight.

10 APU generator PWR

Verify: APU GEN light OFF

CAUTION:! APU generator required to run APU cooling fan. Do not operate APU for more than

5 minutes with APU generator off.

PRE-START

09/10/2009 of 15 Revision 001


Note: If starting Right Engine first, set emergency brake and CROSSFEED.

M 1 Selected engine operate switch MOTOR

Verify: ENGINE START CYCLE light ON

RPM increasing

M 2 Selected engine ignition Press

CAUTION:! Attempting to start with ITT above 150°C will resul t in overtemp.

3 Selected engine Throttle IDLE

4 ITT Check

CAUTION:! If ITT does not rise within 20 seconds, retard throttle to IDLE and motor for 30 seconds.

Wait 1 minute before attempting restart.

5 Selected engine oil pressure Check

6 Hydraulic pressure Check

7 L-GEN light Check

M 8 Selected engine operate switch NORM after 56% RPM

Verify: ENGINE START CYCLE light OFF

9 Engine instruments Check

ENGINE START

09/10/2009 of 15 Revision 001


1 CDU As required for alignment

2 CTVS/AVTR STBY

3 Radios As required

4 TV monitor switch POWER (if required)

5 IFF STBY

6 Air refueling door Check

7 Crossfeed OFF

8 Emergency brake handle OFF

9 HUD mode TEST

10 RWR PWR

11 Armament control panel lights Test

12 Navigation mode Set

13 TISL CAGE

14 ILS PWR

15 TACAN TR

16 Winshield defog/deice As required

17 Signal lights Test

PRE-TAXI (1 of 4)

09/10/2009 of 15 Revision 001


18 Flaps Cycle

19 Speed brakes Test

20 Speed brakes Close

21 Flight controls Check

a. SAS OFF

b. Control surface movement Free and correct

c. Hydraulic pressure Check

d. Full cycle controls No aileron/rudder interconnect

22 SAS Check

a. Anti-skid switch ANTI-SKID

b. SAS ENGAGE

c. Monitor test switch L (hold)Verify: SAS switches disengage

d. SAS ENGAGE

e. Monitor test switch R (hold)Verify: SAS switches disengage

f. SAS ENGAGE

g. Emergency disconnect PressVerify: Anti-skid switches OFF

h. SAS ENGAGE

i. Aileron/rudder interconnect test Perform

j. Pitch trim compensator test Perform

23 Trim Check

24 Takeoff trim Set

Verify: T/O TRIM light ON

25 Pitot heat Check

26 IFF Test Perform

27 TV monitor test Perform

PRE-TAXI (2 of 4)

09/10/2009 of 15 Revision 001


28 HUD display As required

29 CTVS/AVTR BIT Check

30 RWR Test and set

31 ECM Standby

32 TACAN Test

33 Flight instruments Check

a. ADI Set and check

b. HDG SYNC

c. Standby ADI Uncage

d. VVI Zero

e. Airspeed indicator Check

f. Altimeter Set and check in ELEC and PNEU modes

? Continue if INS alignment is complete

34 CDU mode NAV

Verify: INERTIAL NAV light OFF

35 Navigation mode NAV CRS

PRE-TAXI (3 of 4)

09/10/2009 of 15 Revision 001


36 INS Check

a. Steerpoint Select

b. HUD mode TEST

c. HUD mode NAV

d. CDU page INS

e. CDU test line Press

(1) CDU Test Perform

(2) CADC Test Perform

(3) MBC Test Perform

f. Navigation Mode MANVerify: Manual mode

g. Navigation Mode HARSVerify: HARS mode

37 INS data Record

38 Navigation mode As required

39 TISL Check

a. Mode switch CAGE

a. BITE switch PressVerify: DET and ACD lights ON then OFF

CAUTION:! APU should run for at least 2 minutes after end of last engine start cycle.

! Above 75°F, ECS and APU should be operated to provi de adequate cooling for INS.

40 APU generator OFF/RESET

41 APU OFF

42 Idle RPM test Perform

PRE-TAXI (4 of 4)

09/10/2009 of 15 Revision 001


1 Nosewheel steering Engage

2 Throttles As required

3 Brakes Check

4 Flight instruments Check

a. Turn needle Check

b. Compass Check

c. HUD heading tape Check


a. Idle RPM At or above minimum idle speed

b. ITT < 675°C

CAUTION:! Idle RPM below minimum idle speed indicates possible CIT sensor failure; abort.

! ITT temp above 675°C indicates failng outer transit ion liner; abort.

2 Flaps Set for takeoff

3 Speed brakes Closed

4 IFF As required

5 Trim Set to Takeoff

6 TACAN Set

a. Navigation mode TCN

b. Course selector window Set

7 Windshield defog/deice As required

PRE-TAKEOFF (1 of 2)

TAXI

09/10/2009 of 15 Revision 001


8 Canopy Closed and locked

Verify: CANOPY light OFF

9 Ejection seat ARMED

10 Exterior lights As required

LINEUP CHECK

1 Flight Instruments Check

2 Anti-skid switch ANTI-SKID

3 Pitot heat ON

4 Run up test Perform

a. Brakes Set

b. Throttles 90% RPM

c. Engine instruments Check

d. Warning and caution lights No faults indicated

e. Throttles IDLE

1 Nosewheel steering As desired

2 Brakes Release

3 Throttles MAX


5 Rotation 10 kts below TO speed

6 Pitch 10°

TAKEOFF

PRE-TAKEOFF (2 of 2)

09/10/2009 of 15 Revision 001


1 Landing gear Retract after positive climb

2 Flaps Retract

3 Climb out As briefed

AFTER TAKEOFF

09/10/2009 of 15 Revision 001

a10a startup rev001 - forums.eagle.ru

Documents