DriveTite™ & DriveTite Surface™

Viewrail’s lineup of crimpless cable railing is getting a lot of love from contractors and DIY heroes alike for its great looks and simple installation.

For questions about DriveTite or any other products, call your Viewrail representative today!

© 2018 Viewrail All Rights Reserved. • (574) 742–1030 • www.viewrail.com

DriveTite Surface

The newest innovation to the DriveTite family, DriveTite Surface, is taking ease of installation to a whole new level. The hidden components are mounted to the surface of the post, which makes Surface perfect for hollow columns or other applications with mounting material as thin as an inch and a half!

Whether you’re in the countryside or on the coast, the beauty and strength of 316 stainless steel will keep your railing safe and looking great for years.

DriveTite

Bring the elegance of cable railing to your project with DriveTite. The simple fi tting compression process (shown at the bottom right) removes the extra work of traditional cable crimping and is performed with familiar hand tools. This makes DriveTite a great choice for DIY enthusiasts.

Staying true to Viewrail’s love of hidden fasteners, DriveTite will keep your view uncluttered for a modern look that’s sure to impress.

POST

CABLE

Surface Cover

Barrel Fitting

Tensioning Screw

Cable Wedge

POST

CABLE

WoodAngleInsert

Barrel Fitting

Tensioning Screw

Cable Wedge

1197531246810

Cable Wedge(Notch facing in)

Compress

Notched forCable

Barrel Fitting

Cable

Modified Pliers

POST

11/16" Hole1" Deep

11/16" Forstner Bit

3 1/8" Max Cable Spacing Measure with String

48" Max Post Spacing

Transfer Measurement

from Stringto Tape Measure

Cut Cable to total measurement fromprevious step.

Now tighten both ends to tension cables.Use the Holding Tool to keep Barrel Fittingvertical while tightening.Tension cables in this order Remove adhesive

backing.

Press Wood Angle Insert into hole withthumbs.

Tap with wood blockuntil fully seated.

Slide Wood Angle Inserts onto Cable.Make sure prongs face posts that they will enter.

then ADD 1 1/4"

1/8" Pilot Hole1" Deep

Tape one endMark the other end

String is included in the DriveTite Installation Kit

POST

CABLE

TORX BIT

Make sure Barrel Fitting is started into hole before driving screw.

Clear any debris from hole.

DO NOT TIGHTEN YET!Get the screw started,but don’t tighten.

HoldingTool