using a hardware license key - mcsira
TRANSCRIPT
UFED PRO
Using a Hardware License Key
© Copyright McSira BVBA/SPRL, all rights reserved
McSira BVBA/SPRL
Brussels Belgium Contact:[email protected]
You can use a HASP hardware license key (dongle), provided by Cellebrite as part of your UFED system, to activate the locally installed copy of UFED Physical Analyzer. NOTE: Using a hardware license key provides you with a “mobile license”, enabling you to take your license on the road and use it to activate a copy of the UFED Physical Analyzer application wherever you are. To activate the UFED Physical Analyzer application using a hardware license key:
1. Connect the hardware license key to a USB port on your computer.
NOTE: The HASP dongle drivers must be installed in order to use a hardware license key. If the drivers were not installed during the software installation process, you can run the installation process again: Software Installation Insert the UFED Physical Analyzer CD into your computer’s optical drive and browse the contents. Installing the UFED Physical Analyzer
1. Double click on the setup program to install the UFED Physical Analyzer application. 2. Select the setup language, then click OK to continue.
3. Follow the installation setup wizard prompts. 4. At the end of the installation process you will be prompted to install the HASP USB Key drivers. If you
intend to activate the application using a hardware license key (dongle) provided by Cellebrite, check the Install Hasp Dongle Drivers option, then click the Finish button.
After the key was recognized by the operating system, the application will be able to read the license and allow you to continue.
2. Launch the UFED Physical Analyzer application. 3. Your UFED Physical Analyzer application is now ready for use.
Contact us: [email protected]