ultraware communications problems

2
Ultraware Communications Problems 1. Cable connection should be 2-3, 3-2, 5-5 with no other pins connected 2. Verify communication parameters 3. Make sure that RS Linx is shut down 4. Go to Programs/Rockwell Software/RSLinx Launch Control Panel and make sure that “Always Run as Service” is NOT checked 5. Go to Tools/ recover communications to do a hardware reset. 6. Make sure that there are no other pins than 2, 3 & 5 connected. 7. Do a recover communications. Go to Tools / Recover Communications and follow the prompts

Upload: nguyen-quang-vinh

Post on 08-Nov-2015

4 views

Category:

Documents


0 download

TRANSCRIPT

Ultraware Communications Problems

Ultraware Communications Problems1. Cable connection should be 2-3, 3-2, 5-5 with no other pins connected

2. Verify communication parameters

3. Make sure that RS Linx is shut down

4. Go to Programs/Rockwell Software/RSLinx Launch Control Panel and make sure that Always Run as Service is NOT checked

5. Go to Tools/ recover communications to do a hardware reset.

6. Make sure that there are no other pins than 2, 3 & 5 connected.

7. Do a recover communications. Go to Tools / Recover Communications and follow the prompts