toshiba 32wlt68 (lcd-tv) failure technical report
TRANSCRIPT
-
Problem
Wont come out of standby when cold (RED LIGHT ON ).Then fault progresses to stuck in standby all the time.
Cause
DDR 2.5V rail missing from Cortez IC preventing boot up
Cure
Re-solder IC420 MP2105DJ-LF-Z on Signal Processing board.Using lead free solder.
WL(T)68 Stuck In Standby
DLS 24/10/09
-
1. Remove Signal PCB2. Remove 3 screws from screening can ( Shown by ) 3. Unfold securing lugs (Show by )
WL(T)68 Stuck In Standby
DLS 24/10/09
-
WL(T)68 Stuck In Standby
4. Unfold securing lugs (Show by )
DLS 24/10/09
-
5. Remove the top Shield and then the bottom shield
NOTE : There are 3 heat sinks that are clipped onto the shield which may be stuck on the 3 processing ICs These must be fitted when re assembling after repair
WL(T)68 Stuck In Standby
DLS 24/10/09
-
6. Locate IC420 on bottom of PCB, and resolder
Lead free solder must be used.
7. Reassemble in reverse order
WL(T)68 Stuck In Standby
DLS 24/10/09
WL(T)68 Stuck In Standby