the integrated data warehouse as a control and …
TRANSCRIPT
THE INTEGRATED DATA WAREHOUSE AS A CONTROL WAREHOUSE AS A CONTROL
AND DECISION MAKING SUPPORT SYSTEM IN THERMAL SUPPORT SYSTEM IN THERMAL
POWER PLANTS
Ninel Čukalevski, Goran Jakupović, Suzana Cvetićanin
Lj. Mihajlović, Z. Karać
Presented at Power plants 2010, V. Banja, Serbia, 28 October 2010
j j
28 October 2010
Presentation Content:
1. Motivation, challenges2. Existing ICT situation at TPP N. Tesla A3. TPP-DW System architecturey4. TPP-DW data content5 ECTL programs5. ECTL programs6. System platform 7. Conclusion
Motivations, long term
• Liberalization and re-regulation of ESI• New players (IPP, GenCo), Market,
concurrency. y• Power system complexity increase. • Business technical and commercial-• Business technical and commercial-
financial aspects getting more complex.N it b ildi l d• New capacity building slow down
• Fuel prices increase+ Economy crisisp y
Challenges in Generation
• Increased requirements on environment protection (emission of CO2, SOx, NOx,...).protection (emission of CO2, SOx, NOx,...).
• Older and older equipment/plants require best possible O&M practicebest possible O&M practice.
• Older workforce, with valuable knowledge base that can be easily lostbase, that can be easily lost
• Pressure to reduce production cost (€/MWh)
• Increased threats to security, …y
Challenges for GenCo’s and IPP’s
• To be able to take competitive technical and commercial decisions need adequate and timely
d t f th l t th lprocess data from the power plants on the regular basis.
• Numerous power plant data are needed• Numerous power plant data are needed(technical, process historic, real-time and non-real time). time).
• Between them on-line, real-time, available unit capacity, unit efficiency and unitunit capacity, unit efficiency and unit production cost (as ¢/kWh, based on the unit heat rate) are of the prime importance.
Typical GenCo’s and IPP’s ICT support
• On-line real-time performance monitoring and analysis system (of themonitoring and analysis system (of the individual power plants/units are to be followed and analyzed), fleet wide.be followed and analyzed), fleet wide.
• MMS plus activities on coordination of power plant maintenancepower plant maintenance.
• Generation Management System(G S) d f f i(GMS) are used to perform functions related to resources scheduling.
Motivation: New possibilities
Progress in the area of automatic control methods, and toolsmethods, and toolsModernization of process interface, intelligent transmitters gas/liquid analyzersintelligent transmitters, gas/liquid analyzers, sensor networks, increasingly wireless...Progress in the area of ICT: DW DM BIProgress in the area of ICT: DW, DM, BI…Modernization of control of almost all units at EPS of Serbia, ongoing
Existing ICT for process control at TPP TENT
DCS Typical constraints
• All data are in local proprietary archives, relatively closed. Proprietary protocols.
• Used solely for process monitoring, command and automatic regulation. Modest se of the data o tside the nit• Modest use of the data outside the unit control room.
• No automatic relation with the Daily report• No automatic relation with the Daily report application. i.e. repeated manual data entry.
• Data in ’’siloses’’, un related.Data in siloses , un related.• Minimal use of analytic applications.
TPP DW System proposed
• The DW-TPP system proposed and developed, in its essence represents a specific information system of th DSS t i t d d f d i i ki tthe DSS type, intended for decision making supportin the domain of TPP operation effectiveness, operations planning and energy efficiency.p p g gy y
• The system as its central part has an integrated data warehouse (IDW) that contains all relevant ( l t) l ti d hi t i d t b t(almost) real-time and historic process data, but also data from other sources.
• Additional service and user software (ECTL, T-View)• Additional service and user software (ECTL, T View)• Fits in designed multi level control hierarchy
TPP N.Tesla A DW Architecture
TPP-DW data content• Each unit generates about 4000-6000 measurements
on every scan (2-5 seconds). Adding calculated and derived data, we come to about 10.000 data per unit, or 60.000 ''measurement'' data per TPP (6 units).
f l l / i• Of approximately 1600 analogue measurements/unitabout 1000 are from boiler, 400 from turbine and 200 from generator and auxgenerator and aux.
• Available measurements: electrical (like I, V, f, P/Q, Wa/Wr etc ) and non-electrical (like temperatures Wa/Wr, etc.) and non electrical (like temperatures, pressures, levels, flows, vibrations, speed of rotation, concentration, etc.) that plant/unit SCADA/DCS/PLC system can provide.
TPP-DW contains two main data groups:
• ''Catalog'', model data that describe the plant/unit structure and their elements. p
• Data extracted from the SCADA/DCS systems, before all measurements from the y ,process.
• Historical (time tagged) DW data are organized ( gg ) gin three tables (''archives''): -Daily archives (with a 5-15 min. resolution)-Monthly archives (with a daily resolution)-Yearly archives (with monthly resolution)
ECTL-B Programs functions:
• Access to real-time data in the DCS run-time tsegments
• Data extraction from the DCS historical archives
• Data extracted processing and their conversionp gin a form suitable for data transfer
• Connection and processed data transfer to • Connection and processed data transfer to Oracle data base
ECTL-B Programs structure
IT Platform: heterogeneous, stnd. based
• API: C++• ECTL: C++• RDBMS/DCS side: My SQL/ y Q• RDBMS/DW side: Oracle 11g• Viewer Application: Oracle APEX• Viewer Application: Oracle APEX
Conclusions
The DW for the biggest TPP at EPS that:
1. Integrates at the power plant level relevant process data collected from the individual unit DCS’s and other PP data sources.DCS s and other PP data sources.
2. Serve as a platform for different applications that will use mainly historic process data from the data warehouse.
3. The system was developed in strong cooperation with the end user (EPS TENT A) and is based onwith the end user (EPS TENT A) and is based on robust design approaches and technologies used.
Contact:
Dr. Ninel Čukalevski, dipl.inž.p
Institut Mihajlo Pupin-AutomatikaVolgina 15Volgina 15Beograd, Serbia
Thanks for your Thanks for your attention!
Q ti ?Questions?