spark 20 plasma cutter + compass kit · cut thickness 6mm (steel /stainless steel) 4mm (alu) plasma...
TRANSCRIPT
090511
Conforme EN 60 974-1
PLASMA CUTTER
+ Compass kit Réf 013261
SparK 20 Cut thickness ���� 6mm (Steel /Stainless steel) ���� 4mm (Alu)
Plasma cutter with Inverter technology
The Spark 20 is ideal for maintenance work and car body repair.
With a solid and reinforced design, the SPARK 20 allows
high quality cutting even on painted surfaces:
� Cuts up to 6 mm steel, stainless steel and cast iron.
� Cuts up to 4 mm aluminium and copper.
Very accurate, this device enables you to cut 0.6 mm metal
sheets at low intensity without distortion.
Quality cutting without distortion
� Easy and simple to use, must be connected to :
� Power source of 230V (16A)
� A compressed air system (pressure from 2,5 to 4 bars; air flow to 80l/mn)
� Torch: 4 m with a safety trigger to avoid accidental start.
� Reinforced protection for use with generators, and against
permanent overvoltage up to 400V (factory tested)
� IP23 (protected against rain / dust): ideal for outside work.
� Compass for circular cuts up to 134 cm
Easy to use, fast and safe
(Speed = 15 cm /min at 20A)
ALU : 4 mm max
STEEL : 6 mm max
Easy start (No HF Start)
With the “Pilot Arc” system, the arc starts without
having any contact with the welding sheet.
Starting without HF avoids any electromagnetic
interference (radio, computers, phones, medical
equipment etc…)
To improve the quality of start, Spark 20 is designed
with a dryer filter for compressed air.
Delivered ready to use with additional
consumables: 2 nozzles and 2 electrodes
+ COMPASS KIT
Use: Metal cutting
Thickness: Steel / Stainless steel > 6mm
Aluminium > 4mm
Power source: 230 V (16 A)
50/60 Hz
Settings: 5 � 20 A
Performances: 77% at 20A (at 20°C)
34% at 20A (at 40°C)
60% at 16A (at 40°C)
Uo Load voltage : 410 V
Protection: IP 23
Weight : 10,5 kg
Dimension (cm) : 18 x 40 x 27,5
SPECIFICATIONS