south oc pediatric - telepacific planning
TRANSCRIPT
South OC Pediatric Dental:Telepacific SmartVoice Conversion
Prepared by:
Mark Gallagher
Sales & Project Engineer
949-544-8612
Current Telco Setup
Customer is moving from this configuration to the one on the next
two slides
New Telepacifc Configuration
Physical Considerations
The Telepacific routers for both locations will be mounted in an equipment cabinet
There is limited feed in both locations and we will have to interrupt service at the main location in order to extend the circuits
The circuit extension and turn-up will happen on the same day (1/27/12)
The remaining slides will detail the physical considerations
This is the equipment cabinet at 26302 La Paz.
The room is small and I could not get far enough back to get the whole thing in one pic
Top Half Bottom half
This is the shelf where we will put the
Telepacific router
XO Internet router – no
longer needed
pt-to-pt router – no longer
needed
SonicWALL and iPod can
be moved
This entire cabinet swings open
Toshiba CIX100 phone system,
mounted on wall
The back wall, inside the cabinet
Top Half Bottom half
We will find/make a space to mount the Telepacific 66 block
MPOE at 26302 La Paz
Existing XO equipment
Feed to suite 114
There is not a full 25-pair feed cable there. The feed is five cat5 cables.
Below is a breakout showing how the feed is currently allocated and my suggestion on how we reuse it
This is the equipment cabinet at 26371 La Paz.
The current feed and station cabling terminates on blocks loose in the
cabinet
These blocks will be moved to a backboard and the Telepacific router can be placed in the cabinet
Feed and phone station cabling will terminate on 66 blocks mounted
to backboard
Telepacific router goes in cabinet
MPOE at 26137 La Paz
Feed to Suite 225
Here there are only three cat5 cables for feed
Below is a breakout showing how the feed is currently allocated and my suggestion on how we reuse it
Thank you for viewing.Please call/email me with any
question or concerns
Mark Gallagher
Sales & Project Engineer
949-544-8612