solidwork project (office chair)
DESCRIPTION
Solidwork Project (Office Chair)TRANSCRIPT
CHAPTER 4
DESIGN OF PROJECT
4.1 INTRODUCTION
This chapter will focus on fully design of the project. Besides, each components of office chair are presented using Solidwork 2008.
4.2 COMPONENT OF OFFICE CHAIR
Figure 4.2.1 (Seat )
Isometric view
Figure 4.2.2
Isometric view
Figure 4.2.3 (Arm Supporter)
Isometric view
Figure 4.2.4 (Wheel)
Isometric view
Figure 4.2.5 (Angle Adjuster)
Isometric view
Figure 4 .2.6 (Height Adjuster)
Isometric view
Figure 4.2.7 (Stand)
Isometric view
Figure 4.2.8 (Hydrolic Shaft)
Isometric view
Figure 4.2.9 (Connecters)
Isometric view
Figure 4.3 (Exploded View)
Top view
Bottom view
Right view
Front view
Figure 4.4 (Full view)
Isometric View
Top view
Bottom view
Right view
Front view