safety data sheet issue date: 02/02/2016 suretac 1925 - …€¦ · 02/02/2016 suretac 1925 -...
TRANSCRIPT
Safety Data Sheet
Product Use:
Supplier:
Emergency:
Section 2 Hazards Identification GHS Classification GHS Pictograms
Signal Word:
Hazard Statements Precautionary Statements
Section 3 Composition information on ingredients
Substance:
Other ID:
Definition:
CAS # Component Concentration % Registration
Section 1 Product and Company Identification Product Name:
Issue Date: Page: 1/5
02/02/2016SURETAC 1925 - 71925000
SURETAC 1925 - 71925000 71925000
Tackifier
Dyna-Tech Adhesives Inc.Country Club RoadGrafton, WV 26354
Tel: (304) 265-5200 Fax: (304) 265-5202 Emergency Phone Number: 1-800-847-7773
Health, Skin corrosion/irritation, 3Health, Specific target organ toxicity - Single exposure, 3
WARNING
H316 - Causes mild skin irritationH335 - May cause respiratory irritation
P264 - Wash thoroughly after handling.
Mixture
Acrylated compounds
A mixture of acrylated compounds and additives.
No Hazardous Ingredients
per OSHA (29CFR1920.1200)
Safety Data Sheet Issue Date: Page: 2/5
Section 4 First Aid Measures
Contact with eyes:
Skin contact:
Inhalation:
Ingestion:
Section 5 Firefighting Measures
Suitable Extinguishing Media:
Unsuitable Extinguishing Media:
Protective Actions:
Protective Equipment:
Section 6 Accidental Release measures
Personal precautions:
Environmental Precautions:
Containment Methods:
Section 7 Handling and Storage
Precaution for safe handling:
Remarks:
02/02/2016SURETAC 1925 - 71925000
In case of accidental contact, immediately flush with large amounts of low pressure water for 15minutes. Remove contact lenses if applicable to ensure thorough flushing. Get medicalattention if irritation persists.Avoid prolonged skin contact. Wash with warm soapy water if skin exposure occurs.
Remove person to a fresh air area. Seek medical attention.
If swallowed - DO NOT induce vomiting. Seek medical attention. Note to Physician - Nospecific antidote. Supportive care. Treatment based on judgement of the physician in responseto the reaction.
Promptly isolate the scene by removing all persons from the vicinity of the incident if there is afire. No action shall be taken involving any personal risk or without suitable training.
Fire-fighters should wear appropriate protective equipment and self contained breathingapparatus (SCBA) with a full face-piece operated in postive pressure mode.
No special measures are required.
DISPOSAL: Dispose material in an approved site in accordance with all local, county, state,and federal regulations.Small spills can be cleaned up by absorbing with towels, rags or paper.Take up mechanically.
Provided good ventilation and/or local exhaust systems are used, the Occupational ExposureLimit(s) stated in Section 8 should not be exceeded.
Avoid inhaling vapors. Avoid inhaling dust. Wash hands, forearms and face thoroughly afterhandling compounds. Keep away from heat and direct sunlight.
Use an extinguishing agent suitable for the surrounding fire. Use water, foam CO2 or drychemical. SPECIAL FIRE FIGHTING PROCEDURES: Water may be used to cool containers.
None known.
Safety Data Sheet Issue Date: Page: 3/5
Section 8 Exposure controls / Personal protection
Ventilation:
Respiratory:
Gloves:
Eye protection:
Washing facility:
Section 9 Physical and chemical properties
Physical State: ____________________
Color: ____________________
Odor: ____________________
pH: ____________________
Density: ____________________
Ignition Temperature: ____________________
Melting Point: ____________________
Boiling Point: ____________________
Flash Point: ____________________
Burning Time: ____________________
Solubility: ____________________
Decomposition Temperature: ____________________
Section 10 Stability and Reactivity
Reactivity:
Stability:
Hazardous reaction:
Conditions to avoid:
Materials:
Decomposition:
02/02/2016SURETAC 1925 - 71925000
Use process enclosures, local exhaust ventilation or other engineering controls to keep workerexposure to airborne contaminants below any recommended or statutory limits. Dischargefrom the ventilation system should comply with air pollution regulations.
May be necessary to minimize exposure to vapors. Depending on the nature andconcentration of the airborne material. In case of vapor formation use respiratory equipmentwith appropriate filtering. If ventilation is inadequate, use approved respirators.HMIS PP, B | Safety Glasses, Gloves Impervious gloves specified for the material to behandled are recommended to prevent skin contact and irritation.
ANSI approved eye protection is recommended to safeguard against potential eye contact,irritation or injury. If eyes become irritated, flush with water to relieve irritation. If still irritated,seek medical attention.Wash hands, forearms and face thoroughly after handling chemical products. Washcontaminated clothing before reuse. Ensure eyewash stations and safety showers are closethe workstation location.
Not availableLiquid
White >100 C (212 F)
Not available. >200 F
Not available Not available.
8.4lb/gal Dispersable in Water
Not available. Not available.
No specific test data related to reactivity available for this product.
Stable
Under normal conditions of storage and use, hazardous reactions will not occur.
Prolonged exposure to excessive heat.
No specific data.
Degradation products of the polymers and their additives may be formed. Carbon monoxide;carbon dioxide.
Safety Data Sheet Issue Date: Page: 4/5
Section 11 Toxicological Information Exposure
Inhalation:
Skin:
Eyes:
Ingestion:
Short Term Effects
Immediate:
Delayed:
Long Term Effects
Immediate:
Delayed:
Toxicity
Measures:
Symptoms:
Reporting:
Section 12 Ecological
Toxicity:
Degradability:
Bioaccumulation:
Mobility in soil:
Adverse effects:
02/02/2016SURETAC 1925 - 71925000
Inhalation of this product under normal ambient and ventilated processing conditions isnormally not a problem. Mist may cause irritation to the respiratory tract.
May cause irritation. Minimize skin contact through material handling methods. If contactedby skin wash with soap and water. If irritation develops, seek medical attention.
May cause irritation. If eyes become irritated, flush with water. If irritation persists, seekmedical attention.May cause abdominal pain, irritation to the mouth and esophagus. Seek medical attention.
Not available.
Not available.
Not available.
Not available.
Under the recommended processing conditions small amounts of residual or decompositionproducts may be discharged. The product has no harmful effects on health if properly handled.
No known significant effects.
Not available.
Not available.
Not available.
Not available.
Not available.
No known significant effects or hazards.
Safety Data Sheet Issue Date: Page: 5/5
Section 13 Disposal Considerations
Precautions:
Landfill:
Section 14 Transport Information (non-mandatory)
Section 15 Regulatory Information (non-mandatory)
Section 16 Other Information
Historical:
Other:
02/02/2016SURETAC 1925 - 71925000
No known significant effects or hazards.
REASON FOR ISSUE: Update
PREPARED BY: Dyna-Tech Adhesives Inc.
Dyna-Tech provides the information herein in compliance with OSHA Hazard CommunicationStandard, 29 CFR 1910.1200 to give warning of hazards, and to inform generally applicableprecautions and control measures which are known to Dyna-Tech. Hazard information isbased on available scientific actual and assumed evidence but is not always obtained fromsources under the direction or control of Dyna-Tech. Dyna-Tech makes no warranty that theinformation is accurate, reliable or complete.
Dispose material in an approved site in accordance with all local, county, state, and federalregulations. Avoid dispersal of spilt material and runoff and contact with soil, waterways,drains and sewers.
DOT (DEPARTMENT OF TRANSPORTATION)Not Regulated.
Not dangerous cargo. Keep separated from foodstuffs.
All intentional ingredients are listed on the TSCA Inventory.
MINERAL OIL PETROLEUM DISTILL SARA311BENZENESULFONIC ACID, DODECYL- SARA311 WHMIS