regenerative blowers - ppe
TRANSCRIPT
www.ppe.com
Order Fax: 800-223-8305
e-mail: [email protected]
Toll Free: USA, Canada & Mexico
800-362-0706
PLASTIC PROCESS EQUIPMENT, INC.6385 MONTESSOURI STREETLAS VEGAS, NEVADA 89113702-433-6385 • FAX: 702-433-6388TOLL FREE: 800-258-8877
E
A
S
T
WE
S
T
8303 CORPORATE PARK DRIVE
MACEDONIA, OHIO 44056
216-367-7000 • FAX: 216-367-7022
TOLL FREE: 800-321-0562
REGENERATIVE BLOWERS(VACUUM PUMPS)
FOR DRYERS, PNEUMATIC CONVEYORS, VACUUM SYSTEMS, ETC.
Manufactured since 1986, the All-Star Regenerative Blowers
are the best choice for applications requiring a quiet, 100% oil-
free, odor-free and non-pulsating air or gas supply.
Regenerative Blowers are also referred to as side channel,
vortex or ring-type blowers.
All-Star Regenerative Blowers (Vacuum Pumps) offer an
alternative to traditional high pressure blowers and pumps. The
regenerative blower is suitable for applications where positive
displacement (PD-type) blowers and pumps have been used.
It’s simple design permits the units to be used as a blower or
vacuum pump - without added parts.
STRADDLE MOUNTED IMPELLER DESIGNHigh bearing temperatures that prove fatal in competitive
blowers are eliminated in the All-Star design because the
bearings are mounted on the outside of the blower housing.
Damaging overhung loads are eliminated in the All-Star design
because a bearing is located on each side of the impeller. This
design permits mounting the blower in any orientation, including
vertical shaft up or down.
FEATURES
• 1/4 to 30 HP
• Air Flow to 950 SCFM
• Pressure to 11.5 psi
• Vacuum to 12”Hg
• Oil & Odor-free
• Single or 3-Phase
• Quiet: 53 to 81 db(A)
Competitive OverhungBearing Design
Inboard bearing subject to• High Heat• High Overhung Load Due To Radial Forces
All Star StraddleMounted Bearing Design
Impeller
Impeller Housing
Outboard bearing• Cooler Operating Bearing• Overhung Load Eliminated
High-efficient dynamicallybalanced impeller
High temperature bearinglubricant melt point 385°F.
Industrial duty, high efficient,1.15 service factor AC motorwith TEFC (IP54) enclosure.
Class H insulation rated to 355º F.
Corrosion resistantaluminum materials used
for blower and motorhousings, conduit boxViton seals suitable
to 500°F protectsthe motor windings
Removable flangesallow blower
change withoutdisassembly of
pilings.
Built-insilencers reducenoise well-belowOSHA Standard
Shock absorbingmounting base
ISO-9001MANUFACTURED IN A
QUALITY SYSTEM CERTIFIED
FACILITY.
RoHSCompliant
C
285