BUSINESS SERIES

PRODUCT DATA

Model: WAP2000

Wireless-G Access Point with Power over Ethernet

RangeBooster Wireless Access Point SolutionThe WAP2000 is a Wireless Access Point ideal for small businesses that want to expand their existing wired networks or create new wireless networks for the workforce or guests. It features RangeBooster technology that is compatible to standard 802.11g but with a range up to two times farther and throughput by up to 35% faster. Unlike ordinary wireless technologies that are hampered by wireless signals that reflect off walls, ceilings, and other objects, RangeBooster uses these multiple signals with two smart receivers at each end (router or access point and client adapter) to boost range and throughput speeds. As a result, a RangeBooster solution reduces or eliminates wireless signal deadspots in offices and other buildings so users can connect to the network in more areas. The WAP2000 comes with 3 dBi antennas for increased power, also helping to extend the range of the Access Point.

Advanced security features like Wi-Fi Protected Access™ (WPA2 Enterprise), make this solution ideal for your business. Integrated Quality of Service (QoS) features provide consistent voice and video quality on both the wired and wireless networks, enabling your workforce to communicate or view video content without disruptions and delay.

The WAP2000 can be powered from its included AC adapter or from a Power over Ethernet (PoE) Switch via Ethernet cabling enabling mounting in ceilings or high on walls where power outlets may not be available.

Additional features like Multiple BSSIDs, Wireless Roaming, Auto-Channel Selection, and Load Balancing give your business added flexibility to keep employees and guests connected. The WAP2000 also features dual firmware images so it remains functional if a firmware upgrade process is disrupted.

Linksys Business Series WAP2000 Access Point is Linksys One Ready. That means it includes the necessary firmware to be seamlessly integrated into a Linksys One data or data/voice network. Once connected, a Linksys One Service Router will discover the WAP2000 device, automatically configure it and make it available to other users on the network. Linksys One technology is automatic and self-configuring.

Standards-based PoE (IEEE 802.3af ) or External DC power

RangeBooster technology for up to twice the range, reduced dead spots, and up to 35% more throughput than standard 802.11g.

Advanced wireless security using Wi-Fi Protected Access™ (WPA2) with up to 256-bit encryption and Support for WMM provides improved QoS over wireless connections for better video and voice performance.

Linksys One Ready for instant integration into a Linksys One network.

WAP2000

PRODUCT DATA

BUSINESS SERIES

Features

10BASE-T/100 BASE-TX Ethernet Port, Autosensing half/full duplex & MDI/MDI-X

Full backwards compatibility with 802.11b

Easy installation and configuration Web Interface

Dual images for resilient firmware upgrades

Supports WEP, WPA-PSK, WPA2-PSK, WPA-ENT, WPA2-ENT authentication (802.11i ready)

SMA detachable Dipole antennae with 1x2 MIMO to increase coverage

Supports Power over Ethernet (PoE) or external DC power

Supports 4 BSSID and 802.1Q VLAN to SSID mapping

Supports SNMP and intuitive Web-based interface

WMM wireless QoS support - upgradeable to 802.11e

Supports wireless roaming based on 802.11F (IAPP)

Supports AP, Bridge Mode and Repeater mode

Supports wireless client isolation

Metal casing

3 year limited warranty

Linksys One Ready - Simple, one-step automated installation and initial configuration

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

•

Wireless-G Access Point with Power over EthernetSpecificationsModel WAP2000Standards IEEE802.11g, IEEE802.11b, IEEE802.3, IEEE802.3u, IEEE802.3af (Power over Ethernet), 802.1p (QoS priority), 802.1Q (VLAN), 802.1X (Security Authentication), 802.11i - Ready (Security WPA2), 802.11e - Ready (Wireless QoS), 802.11F (Wireless Roaming)Ports 10BASE-T/100BASE-TX Ethernet, 12VDC PowerButtons Reset Cabling Type UTP CAT 5 LEDs Power, PoE, Wireless, EthernetOperating System Linux

Setup/Config WebUI Built-In Web UI for Easy Browser-Based Configuration (HTTP/HTTPS)

Management SNMP Version SNMP Version 1, 2c, 3Event Logging E-Mail Notification Remote SyslogWeb F/W upgrade Firmware Upgradeable Through Web-BrowserDiags: Flash, etc. Diags: Flash, RAM, LAN, WLANDHCP DHCP Client

Operating Modes Access Point Access Point Mode, Point-to-Point Bridge Mode, Point-to-Multipoint Bridge Mode, Repeater Mode

Wireless Spec/Modulation Radio and Modulation Type: 802.11b/DSSS, 11g/OFDMChannels Operating Channels: 11 North America, 13 Most of Europe (ETSI and Japan)# of Internal Ant. None # of External Ant. 2 (Omnidirectional) 3dBi SMA DetachableTransmit Power Transmit Power (Adjustable) @ Normal Temp Range: 11b - 18 dBm; 11g - 16 dBmAntenna Gain in dBi 3 Receiver Sensitivity 11.g: 54Mbps@ -72dBm, 11.b: 11Mbps@ -85dBM

Security WEP/WPA/WPA2 WEP 64bit/128bit, WPA-PSK, WPA2-PSK, WPA-ENT, WPA2-ENTAccess Control Wireless Connection Control: MAC-BasedSSID Broadcast SSID Broadcast Enable/Disable802.1X IEEE 802.1X SupportWireless Client Isolation Wireless Client Devices can be Isolated from Each Other Either Within an SSID or Between Two SSIDs

Quality of Service QoS 4 Queues WMM Wireless PriorityGeneral Wireless Roaming based on IAPP Load Balancing Auto-Channel Selection

PRODUCT DATA

BUSINESS SERIES

LinksysA Division of Cisco Systems, Inc.121 Theory Irvine, CA 92617 USA

E-mail: sales@linksys.com support@linksys.comWeb: www.linksys.com

Linksys products are available in more than 50 countries, supported by 12 Linksys Regional Offices throughout the world. For a complete list of local Linksys Sales and Technical Support contacts, visit our worldwide website at www.linksys.com

Check the product package and contents for specific features supported. Specifications are subject to change without notice. Linksys is a registered trademark or trademark of Cisco Systems, Inc. and/or its affiliates in the U.S. and certain other countries. Copyright © 2007 Cisco Systems, Inc. All rights reserved. Other brands and product names are trademarks or registered trademarks of their respective holders.

7081610NC-RR Model: WAP2000

EnvironmentalDimensions 8.66" x 6.69" x 1.50" (220 x 170 x 38 mm)Weight 1.69 lb (0.765 kg)Power 12V 1A DC input, and IEEE802.3af Compliant PoE Max Power Draw: 3.48WCertification FCC, ICES-003, CEOperating Temp. 14 to 131ºF (-10 to 55ºC)Storage Temp. -22 to 158ºF (-30 to 70ºC)Operating Humidity 10 to 90%, NoncondensingStorage Humidity 5 to 95%, Noncondensing

Package ContentsWireless-G Access Point with Power over Ethernet2 x SMA Detachable Dipole Antenna (3 dBi) User Guide on CD-ROM Quick Installation Guide Ethernet Network Cable Power Adapter Registration Card

Minimum Requirements802.11b, 802.11g Wireless Adapter with TCP/IP Protocol Installed Per PCSwitch/Router with Power over Ethernet (PoE) Support Or PoE Injector when used with PoEWeb-Based Configuration: Java-Enabled Web Browser

•••••••

•••