r. ball september 27 th 2012. criteria re-use existing readout systems where possible high density...
TRANSCRIPT
High Density Readout Electronics
R. Ball
September 27th 2012
2
Criteria• Re-use existing readout systems where possible• High density• Build inexpensive adapters to existing systems• Save funds for detector work
Multi-channel candidate is from the ATLAS MDT• High density• Proven usage in ATLAS detector at CERN• Data acquisition to computer files readily available• Existing analysis programs
Overview
9/27/2012
3
Mezzanine cards• 24 input channels each• Amplifier/Shaper/Discriminator for signals from detector• TDC (AMT-3) to digitize signal timing and amplitude• LVDS signaling for output data transmission
Chamber Service Module (CSM-4)• Attaches to as many as 18 Mezzanine cards• Serial to Parallel conversion of input LVDS signals.• Suppression of empty data cycles• Time-division multiplexing of 16-bit output data via fiber
Data Acquisition Computers• Windows PC for direct control of hardware• Linux WS for assembly of fiber data into disk files
Statistics accumulated for data integrity assurance
Components
9/27/2012
4
Readout Electronics on an ATLAS MDT Chamber
9/27/2012
5
Least time count is 0.78ns 80MHz internal and serial output clock to CSM 50MHz 16-bit data stream from CSM to
computers 1kHz sustained trigger rate to computer Input signal amplitude ~150mV
Relevant Mezzanine/CSM Data
9/27/2012
6
Mezzanine cards are designed to plug into ATLAS “Hedgehog” cards.
The HH cards, in turn, plug into the chamber ends The PPS test detectors come in several varieties
• “Standard” panels with 0.1” pitch card edges• Our own detectors with TBD connections• Two connectors chosen, depending on the situation
Standardized on Tyco, 40-pin connectors, 1658012-1 And on Samtec TFML-120-02-S-D
Ultimately adapted to same Tyco connector
Build PPS Hedgehog card• Adapt Tyco connector to Mezzanine connectors• Provide resistive attenuation network to match signal size
Required Adapter PCBs
9/27/2012
7
PPS Hedgehog Card
9/27/2012
8
All panels must provide appropriately sized signals to the Mezzanine cards
Pickoff cards (eg, Pikov-4) for work in air• Provide resistive attenuation network• Provide the Tyco connectors
Prototype panels• High density cabling connected via Samtec connector• Intermediate adapter cards from Samtec to Tyco• Designed to work in vacuum if necessary
More Adapter PCBs
9/27/2012
9
Pikov-4 and Pikov-3 Cards
9/27/2012
10
HEP Experiment quality electronics have been assembled for PPS development work
Minimal expenditures to adapt the hardware for our use.
Highly flexible adapter cards allow examination of a wide variety of situations and resultant signal sizes without adverse impact on the data quality.
Summary
9/27/2012