PULLEY LAGGINGDUNLOP ULTIMA

MADE FROM HIGH ABRASION RESISTANT PREMIUM GRADE RUBBER

OUTSTANDING WEAR LIFEBecause it is made from high abrasion resistant premium grade rubber, Dunlop Ultima Pulley Lagging provides outstanding wear life and value for money. The grooved diamond profile allows moisture to disperse and reduces material build-up and slippage between belt and pulley. The lagging also effectively acts as a wear indicator so maintenance can be planned before the steel face of the pulley becomes damaged.

Dunlop Ultima lagging has a Neoprene based adhesion layer that creates a simple but highly effective bonding to steel pulley surfaces when used with the appropriate bonding system. Ultima is suitable for use on all drive and non-drive pulleys and can also be applied in a single sheet to minimise the number of joints.

HELPLINE+31 (0) 512 585 555We are never more than a phone call away when our customers need our help or advice. This service is extremely well supported by our extensive network of highly reputable Dunlop Authorised Distributors, Vulcanisers and Approved Agents.

ADDITIONAL INFORMATIONWWW.DUNLOPCB.COM

EXCEPTIONAL

WEAR RESISTANCE

FULLY

OZONE RESISTANT(EN/ISO 1431)

LONG LIFE CYCLE

2 YEARS WARRANTY

KEY FEATURES

► Exclusively 'Manufactured in Holland'

► Extending the lifetime of your plant infrastructure

► Protects against against abrasion, chemicals, acid and noise

► Prevents the build-up of transported bulk material, water, snow or ice

► Optimises friction between surfaces of the lagging and the belt

► Safe to handle - fully compliant with REACH regulations

► Excellent adhesion capabilities

► Low maintenance / easy to clean

TECHNICAL INFORMATION

Thickness [mm] Width [mm] Length [m] Unit of measurement Item No.

Ultima 60PL8 1500 10 m2 9560PL08

10 1500 10 m2 9560PL10

THE ULTIMA PULLEY LAGGING RANGE

The Netherlands (Head Office) +31 (0) 512 585 555 • France +33 (0) 130555419 • Spain +34 (0) 93 770 45 97 • Italy +39 0363 906266 • Poland +48 (0) 32 218 5070 • Morocco +212 (0) 522 34 65 80/85 • Russia +7 495 780 88 64 • United Arab Emirates +971 (0) 4 880 6337

DIAMOND PROFILEThe diamond profile for both 8mm and 10mm thicknesses is shown in the diagram below.

T 4 mm

27

47

6

STANDARD DIAMOND

Ultima 60 Standard

Density [g/dm3] 1.17 ± 0.03 ---

Hardness [Shore A] 62 ± 5 ASTM D2240

Abrasion [mm3] 130 DIN ISO 4649 (10N)

Tensile Strength [MPa] 14 ASTM D412

Elongation [%] 350 ASTM D412

Color Black ---

Grooves for easy evacuationof dirt and water

CN Bonding Layer

All information and recommendations in this bulletin have been supplied to the best of our knowledge, as accurately as possible and updated to reflect the most recent technological developments. We cannot accept any responsibility for recommendations based solely on this document.