Mini Power Distribution Board Pro with LC Filter and 5V/12V Out

Wiring Diagram With OSD

Specifications • 2oz copper full plate PCB

• 3-6S batteries supported

• 70A constant, 110A burst

• 36x36mm with 30.5x30.5mm holes

• Integrated LC filter

• 5V step down regulator - 3A

• 12V step down regulator - 600mA

• 5/12V switch for CCD board camera

• 5/12V switch for video transmitter

• 5V and 12V output pads

• Filtered main battery voltage for OSD

• OSD bypass switch for no-OSD setups

• Shunt for OSD video in/out

Camera and VTX Voltage (A and B)

                                                        5V Supply 12V Supply

• Solder the appropriate pads to supply 5V or 12V to

the CCD board camera and video transmitter.

OSD Toggle (C)

Using OSD Not using OSD

• If you are not using an OSD, solder and bridge the

“NO-OSD” pads together.

Battery power leads

• Pigtail for battery connection should be soldered

onto the same pads as ESC pads and NOT on 12v

Accessories pads.

5v/12v out

• When the battery is connected, the 5v and

12v marked LEDs should light up to indicate

that the respective voltage regulators are

functioning