www.novatek-electro.com

RN-111M

RN-111M:

Multifunctional digital display, Direct power load connection

up to 3.5kW (16A), any load through contactor;

Operation mode Selection by Dip-switch;

Maximum and Minimum voltage protection;

Separate setting of Min. and Max. thresholds,

Protection from neutral Break Condition (440V protection);

Auto reset timer settings; Umin.= 160-220V Umax. = 230-280V

RN-113

RN-113:

Multifunctional digital display; Direct power load connection

up to 7.0kW (32A), any load through contactor;

Operation mode Selection by Dip-switch;

Maximum and Minimum voltage protection;

Separate setting of Min. and Max. thresholds;

Auto reset timer settings; Protection from neutral Break

Condition (440V protection); Umin. = 160-220V Umax. = 230-280V

RN-101M

RN-101M:

Direct power load connection up to 3.5KW (16A);

Short circuits & current overload protection;

Over & Under voltage protection; Protection from the neutral Break

Condition (440V protection); Spike Busting; Auto reset timer settings; Multifunction digital display; Umin. = 160-220V Umax. = 230-280V

RN-102

RN-102:

Multifunctional digital display; Direct power load connection

up to 7.0 kW (32A), any load through contactor;

Maximum and Minimum voltage protection;

Separate setting of Min. and Max. thresholds;

Board mounting; Auto reset timer settings; Protection from neutral Break

Condition (440V protection); Umin. = 160-220V Umax. = 230-280V

RNPP-301

RNPP-301:

Multiple protection - from Over & Under voltage, Single phasing, Reverse phase sequence, Phase voltage imbalance;

Independent adjustable setting for the basic parameters;

Capacity of operation within isolated (3 wire) & solidly earthed neutral (4 wire) electrical circuits;

Adjustable trip delay and auto-reset timers;

Urated = 240/415V Umin. = 5-25% Umax. = 5-25% Pimbal. = 1-20%

RNPP-311M

RNPP-311M:

Multifunctional protection from Over & Under voltage, Single phasing, Reverse phase sequence, Voltage imbalance;

Adjustable trip delay and auto-reset timer;

Dip-switches allow to select the type of monitored circuit voltage (400 or 415V) and protection;

Capacity of operation within isolated (3 wire) & solidly earthed neutral (4wire) electrical circuits.

Urated = 240/415V Umin/Umax = 5-50%

RNPP-302

RNPP-302:Multiple protection from Over &

Under voltage, Single phasing, Reverse phase sequence, Voltage imbalance;

Multifunction Digital display; Programmable password

protected settings; Capacity of operation within

isolated (3wire) & solidly earthed neutral (4wire) circuits;

Control over the full phase switching of the contactor;

Seperate trip & reset delay for each parameter;

Urated.=220/380 – 240/415V Umin. = 0-60% / exact value Umax. = 0-30% / exact value

TK-415

Operation Modes: 15 channel timer device; Selectable Sequential &

Combination modes in same device;

Indicator of selected channels; 7 segments LED indications; Cascade connection of several

devices for extended total number of channels;

Memorization of device mode after switching off & program operation restart from stopage;

Programming through software; Inputs for timer start & pause

control, copy of settings; Program can be executed only

one time or cyclic operation possible.

NEW

REV-302

Operation Modes:

Programmable up to one year; Perpetual real time clock with location

parameters (Astro function) Voltage protection relay; Photo sensors input; 2 independent channels with 4 programs per

channel (8 programs) Non-volatile memory can store up to 5000

events; Free programming software with USB

communication; LCD display on front panel; Modes: Yearly, Monthly, Weekly, Daily, Time

delay relay, Pulse relay.

RN-16TM

Perform protection in the following cases:

Max. no. of programmable events in the timer mode upto 420.

Energizing/deenergizing load acc. with the user-required time schedule.

Integrated Photo Relay. Load de-energizing acc. to reaching

certain illumination levels. Load de-energizing in case of

inadmissible voltage variations.

RMT-101

RMT-101 :

Max. current relay; Priority load selection relay; Digital ammeter; Measure & control over the

load current; Dip-switches available to

select the measure-ment range;

Useful for load limiting in case of generator back-up or mains.

Imax.=0-100A

OM-110

OM-110 :

Power limiting relay to cut-off an excessive power load

Continuous control over active & total power capacity;

Threshold & Setting of rated power, tripping time by Dip-switches or potentio-meter knobs

Power management range = 0-20kW or 0-20kVA;

PEF-301

PEF-301 :

Control over voltage on each of available lines;

Select any of the lines with required proper voltage parameters;

Compact automatic fallback panel;

Operation load up to 3.5 kw directly

Wrong voltage fault indication Protection from inter-phase

switching Operation with generators Built-in autoreclosing timer

UBZ-301

Perform complete motor protection in the following cases:

When main voltage is of poor quality.

Mechanical Overloads. Dry stroke and absence of the

load on the motor. Earth leakage protection. Protection and Operation with

the motors from 2.5 to 315 KW.

Data transmission to the upper level on rs-485 protocol.

UBZ-302

UBZ-3 0 2:

Delta/Star switching operation

Cascade motor start (delayed starting of motor one by one)

Built-in current transformers and pts earth leakage protection.

Protection and Operation with the motors from 2.5 to 315 KW.

Data transmission to the upper level on rs-485 protocol.

UBZ-304

UBZ-3 0 4:

Delta/Star switching operation

Cascade motor start (delayed starting of motor one by one)

Built-in current transformers and pts earth leakage protection.

Protection and Operation with the motors from 2.5 to 315 KW.

Data transmission to the upper level on RS-485 protocol.

NEW

UBZ-115

UBZ-115: Unique solution for

submersible pumps; External input for remote Start

& stop the engine Soft start the engine up to

5sec. When main voltage is of poor

quality; Delayed start or rotor lock-up; When mechanical torque is

lost; Provides protection to single-

phase induction electric motors with power up to 5.5 kW (25А).

NEW

OM-310

OM-310 :

Total Power load cut OFF in case of active power basis;

Partial power load cut OFF in case of reactive power basis;

Protection equipment & machinery from faults

Measurement & indication of 3 phase power supply parameters;

Protection and Operation with the motors from 2.5 to 450 KW.

Data transmission to the upper level on RS-485 protocol or RS-232 interface.

RPM-16-4-3

RPM-16-4-3 :

16-channel data recorder; 4 channels for voltage

recording; 3 for current recording; 2 for temp. recording; 2 input channels from standard

signal transducers 5 discreate input(digital)

channels. Present all active information

on LCD screen; Save it to an external USB Flash

memory of up to 2GB capacity with user-specified sampling frequency of 1-36000 sec.

TR-100

TR-100 provide:

Protection of Motor, Generator, Dry-type High voltage transformer;

Temperature measurement on 4 input channels;

4 relay output for Alarm, tripping, Fault,co-oling

LED digital display Indication of parameters

Power supply=24-260V AC/DC;

To provide for communication RS-485 MODBUS RTU interface

Measured temp. range=-40 to +240*c

TR-101

TR-101 provide:

Controlling temperature according to PID principle;

Temperature measurement on 4 input channels

LED digital display Indication of parameters

Power supply=24-260V AC/DC;

To provide for communication RS-485 MODBUS RTU standard protocol;

Detect a break or a short-circuit in the connected sensors;

Measured temp. range=-40 to +240*c

MCK-301-83

MCK-301:

Control both 1-phase or 3-phase equipment.

Built in all possible voltage protections

Control appliances inside satellite communication base station & telecommunication base

Two version are provided:1) MCK-301-85:-control unit for

middle & low temperature refrigerating machines with automatic defrost.

2) MCK-301-61:-control unit for chiller & HVAC application.

LEGAT series

LEGAT Series:

Unique Transformerless scheme of voltage stabilization ;

Output voltage smooth & step-less regulation;

1% output voltage accuracy; Built-in protection from all

faults ; Galvanized insulated from

circuit; 100% output power throughout

all the operation voltage range; Compact & light due to

absence of power transformer inside.