michelin x coach energy z - amazon s3s3-ap-southeast-1.amazonaws.com/michelin-assets/... ·...
TRANSCRIPT
• Better safety and reliability
• Increased casing value
• Fuel saving
All POSITION TUBELESS TYRE SPECIALLY DESIGNED FOR COACH APPLICATION
MICHELIN X COACH ENERGY Z
M I C H E L I N R E C O M M E N D A T I O N S
PLY RATINGLOAD / SPEED
INDEXMAX. AXLE LOAD (KG)
SPEED INKMPH
SECTIONWIDTH (MM)
OVERALLDIAMETER
(MM)
MAX.PRESSURE(BAR / PSI)
RECOMMENDEDRIM (INCHES)
TY
RE
S
IZ
E 295/80 R22.5
Warning: MICHELIN truck tyres are designed and optimized for specific conditions of usage which can be found in the MICHELIN Truck and Bus Tyre Technical Data Book and MICHELIN Truck and Bus Tyre Service Manual. It is therefore, not advisable to use the product in conditions of use outside the parameters for which it was designed for. Operations outside these parameters are identified as abnormal usage and are not eligible for warranty consideration.
Serious or fatal injury may result from tyre failure as a result of operating outside the tyres intended conditions of use. Refer to the MICHELIN Truck and Bus Tyre Technical Data Book (Asia Edition), MICHELIN Truck and Bus Tyre Service Manual, or consult your MICHELIN Truck Tyre professional for recommendations and procedures.
(NOMINAL CONDITION OF USAGE)
18 152/149M 7100/13000 130 9.0/130 304 1052 8.25
Lower operating cost thanks to advanced tread design and process technology providing
All POSITION TUBELESS TYRE SPECIALLY DESIGNED FOR COACH APPLICATION
MICHELIN X COACH ENERGY Z
Lower operating cost thanks to advanced tread design and process technology providing
• Even wear from uniform contact patch• Lower rolling resistance, saves fuel up to 5%*
Better safety and reliabilityIncreased casing valueBetter safety and reliabilityIncreased casing value
• Reinforced crown with full metallic ply enhance crown shock resistance and reduce crown damage due to heat.
• Specially designed metallic cables at bead zone improve bead robustness, thus reduced bead damages.
* Based on Michelin Internal test
New sidewall design and marking for product to right fit.