DUCATI SCRAMBLER SOLO & DUO

SOLO PACK CONTENTS A. PlatformB. Frame brackets x 2C. Spacer 30mm D. Spacer 15mmE. Washers x 2F. Mounting bolt 40mmG. Mounting bolt 55mmH. Frame bolts 25mm x 2

DUO PACK CONTENTSAS SOLO x 2

A

B

C

D

E

F

G H

HH

SADDLEBAG PLATFORM FITTING INSTRUCTIONS

G

C

1. MOUNTING FRAME BRACKETSUndo the 4 rear fender screws to remove the fender and rest it on the rear wheel.

Mount the frame brackets B with bolts H to the mounting points on the Ducati Scramber sub-frame but do not fully tighten the bolts at this point. We recommend you use a low strength thread-lock.

2. PLATFORM MOUNTINGMount the platform as illustrated, make sure the 30mm spacer C and 60mm mounting bolt G are at the rear of the bike.

Tighten bolts G and F to line-up the platform brackets. Now the frame bolts H can be fully tightened.

The rear fender can now be replaced.

FOR DUO MOUNTING REPEAT THE SAME PROCESS ON BOTH SIDES.

F

D

FRAME BRACKETSFor ease of use, we recommend that you leave the Frame Brackets mounted to the bike when the platforms are not being used.

The Platforms can quickly be remounted at any time without the need to remove the rear fender.

MOUNTING THE SADDLEBAGS Please read the full mounting instructions included with the Kriega Saddlebags. In addition to these instructions, it is important make sure the closure straps are threaded through the 2 holes on the Platform to hold the bag firmly on the bike.

The whole Kriega range is built to perform without exception. As a commitment to quality all packs are Guaranteed for 10 years against defects in materials and manufacture.

KRIEGA FITTING VIDEOS www.vimeo.com/kriega

It is the owner’s responsibility to ensure the saddlebag/s are attached in such a way that it does not damage or put at risk the owner or the property of the owner. Do not exceed the UK legal speed limit. This product has only been tested for up to UK road legal speeds.