kawasaki zx-6r ninja s u p p l e m e n t a r y m a n u a l · kawasaki zx-6r ninja 2009-2012 mount...
TRANSCRIPT
www.healtech-electronics.com
S U P P L E M E N T A R Y M A N U A Lfor iQSE-1 + QSH-P4A
PAGE 1/3
Remove the airbox.
Kawasaki ZX-6R Ninja2009-2012
Remove the black framecovers below fuel tank.
Remove the main seat.
Remove or lift up the fuel tank.
Remove the black framecovers below fuel tank.
Remove the main seat.
Remove or lift up the fuel tank.
www.healtech-electronics.com PAGE 2/3
Plug QSH connectors in-line with the ignition coil
connectors.(black, 2-pole connectors below airbox)
Connect QSH black wire terminal to the battery
negative terminal.
S U P P L E M E N T A R Y M A N U A Lfor iQSE-1 + QSH-P4A
Kawasaki ZX-6R Ninja2009-2012
Mount the QSE sensor.(Replace the bolt with the one supplied.
Tighten the bolt in this position byabout 5-6 Nm.
If you do not have a torque wrench,tighten the bolt until the
shift arm is tight on the gearbox shaft.For different mounting options,
refer to the sensor install guide.)
www.healtech-electronics.com PAGE 3/3
Typical position for theQuickShifter easy.
Secure the module properly.
S U P P L E M E N T A R Y M A N U A Lfor iQSE-1 + QSH-P4A
Kawasaki ZX-6R Ninja2009-2012