MECHANICAL DATA SHEET

SHELL AND TUBE HEAT EXCHANGER

PLANT ITEM No. 24590-BOF-MB-DEP-RBLR-00001 DATA SHEET No.

Rev.

24590-BOF-MBD-DEP-00001 1

Page 1 of 2

Project RPP-WTP Description DEP Evaporator Reboiler

Project No. 24590 Reference Drawings (1) 24590-BOF-ME-DEP-00002001, Rev. 1

Site Hanford Reference Calculations (Internal Use Only)

(2) 24590-BOF-MEC-DEP-00003, Rev. A (3) 24590-BOF-M6C-DEP-00009, Rev. B

Building 25/Indoors Reference Documents (Internal Use Only)

(4) 24590-WTP-DB-ENG-01-001, Rev. 5 (5) 24590-WTP-Z0C-W13T-00010, Rev. G (6) Deleted (7) 24590-BOF-M6WX-DEP-00003002, Rev. 1

General Data (Ref. 2) Quality Level CM TEMA (Class/Type) B ** Seismic Category SC-IV Flow Type (Counter current, etc) Counter Current Radiation Level Designator (Note 4) R4 Contamination Level Designator C5 Design Code ASME VIII Div 1 Heat Exchanger Duty Btu/hr 6,013,000 Code Stamp Yes Heat Exchanger Area ft2 676 NB Registration Yes T (LMTD/Corrected LMTD) F 83.7 83.7 Insulation (Note 3) Heat Conservation Not to exceed wet weight lb 13,000 Ambient Room Temp (Min/Max) °F 59 / 113

Thermal/Hydraulic Data (Ref. 2) (Note 7) Shell Side Tube Side

Fluid Name Steam

(IN) Condensate

(OUT)

Evaporator Concentrate

(IN)

Evaporator Concentrate

(OUT) Fluid Quantities: Total lbm/hr 6177 2366711 Condensable Vapor 6176 3 0 Liquid 0 6173 2366711 Noncondensable 1 1 0 Normal Temperature F 206 206 116 118.5 Maximum Temperature F 300 (Ref. 7) 300 (Ref. 7) 121 123.6 Density lbm/ft3 0.022 N/A 84.3 Viscosity cP 0.012 0.34 15 Molecular Weight lbm/lbmol 18 18 18 Molecular Weight, Noncondensable lbm/lbmol 29 29 29 Specific Heat Btu/lbm-F N/A N/A 1 Thermal Conductivity Btu/hr-ft-F N/A N/A 0.37 Latent Heat Btu/lbm @ F 974.1 N/A N/A Normal Inlet pressure psig -1.35 (Note 6) 6 (Ref. 3) Max Inlet Pressure psig -1.35 (Note 6) 21 (Ref. 3) Tube side Velocity ft/s N/A 6.86 Pressure Drop (Actual) psi 0.18 4.88 Fouling Resistance (Min) hr-ft2-F/Btu 0.0015 0.004

Mechanical Design Data Shell Side Tube Side Design Pressure (Max/Min) psig 50 Full vacuum 50 Full vacuum Design Temperature (Max/Min) F 300 40 175 40 Corrosion/Erosion Allowance inch 0.04 0.0

Shell ID inch (Ref. 1) 33

Dimensions (H (T-T) x D) ft. (Ref. 1)

12 4 ”H x 2’ 9”D

Total Number of Tubes / Tube Thickness (Nominal) / (Minimum) (Ref. 1) (Ref. 2)

222 / 0.065” / 0.060”

Tube OD / Length (Nominal) (Ref. 2)

1.5” / 8.0’

Tube Pitch / Layout / Clearance (Ref. 2) 1.875” / Triangular / 0.375” No. of Tube Passes

(Ref. 2) 2

Issued byRPP-WTP PDC

---- I T -

I ~

I - -I -----,

I

1-

I - ,....__

~

I 1---

--I -I -I

1---- I ,__ I I

I I I ~

I -~

I ,__ I ,__ I - I

~

I -~

I - ~ --

- ~ --

-_J

-I ±=== I

-I 7 -

I I -

1 --

MECHANICAL DATA SHEET PLANT ITEM No. 24590-BOF-MB-DEP-RBLR-00001

SHELL AND TUBE HEAT EXCHANGER • DATA SHEET No. Rev. 24590-BOF-MBD-DEP-00001 1

Material Data Shell SA 240 316L SS (max carbon 0.030%) Channel/Bonnet SB 575 (Hastelloy C-22) UNS N06022 Plenum Cover SA 240 316L SS (max carbon 0.030%) <Tube-Side) Tube SB 622 (Hastelloy C-22) UNS N06022 Head SB 575 (Hastelloy C-22) UNS N06022

SMLS Stationary Tube Sheet SB 575 (Hastelloy C-22) UNS N06022 Body/Head Flange SA 240 316L SS (max carbon 0.030%) Shell Side Gaskets N/A Gaskets SB 575 (Hastelloy C-22) UNS N06022

Spiral Wound with Thermiculite Filler with Inner and Outer Rings

Partition Seals N/A Baffles/Supports SA 240 316L SS (max carbon 0.030%) Insulation Note3 Forgings (Shell side) SA 182 F316L (max carbon 0.030%) Bolting SA 193 BBM UNS S31600 w/ SA 194 Forgings (Channel) SB 564 (Hastelloy C-22) UNS N06022

BM Nuts

Construction Data Cross Baffle Type (Ref. 1)** % Baffle Cut (Dia.) 50%* Spacing (c/c) inch (Ref. 1)**

Bypass Seal None* Longitudinal Seal Type None* Expansion Joint Type Annular Rings at Arranaement Distribution Shell* Tube Support Type Flat Plate* U-bend Support Type NIA Weight of Bundle lbr 2,800*

Operating Weight lbr 11 ,700* Full of Water lbr 12,600* Weight of Shell lbr 7,250*

Notes Seller to fill in data where indicated by double asterisk (**). Data from Seller's proposal indicated with asterisk (*). Seller to confirm all data. Notes 1. The contents of this document are Dangerous Waste Permit affecting. 2. Please note that source, special nuclear and byproduct materials, as defined in the Atomic Energy Act of 1954 (AEA),

are regulated at the U.S. Department of Energy (DOE) facilities exclusively by DOE acting pursuant to its AEA authority. DOE asserts, that pursuant to the AEA, it has sole and exclusive responsibility and authority to regulate source, special nuclear, and byproduct materials at DOE-owned nuclear facilities. Information contained herein on radionuclides is provided for process description purposes only.

3. DEP-RBLR-00001 is designed with provisions for 4-inch thickness of heat conservation (HC) insulation. The top head insulation is Expanded Perlite (Density= 13 lb/ft3), the bottom head insulation is Mineral Fiber Blanket (Density= 8 lb/ft3), and the shell insulation is Mineral Fiber Semi Rigid Board (Density = 8 lb/ft3 ). The insulation is provided and installed under an insulation subcontract.

4. This equipment is located in an R4 radiation area (Maximum Radiation Area), which is designed to have a target radiation level of less than 25 mrem/hr (Ref. 4, Table 5-1 ). The average contact dose rate is 6.56E+01 rad/hr for an equipment life of 21+ years (Ref. 5, Table 8-1).

5. See Ref. 1 for connecting piping sizes and end connections. 6. Ref. 2 gives the normal and maximum pressures to be 13 psia. This is converted to psig by subtracting 14.35. 7. All properties shown are given for the maximum temperature (sizing case). The shell-side density and viscosity are

provided at the maximum film temperature of 185'F.

Approva Rev Description Originator Checked Reviewed Approved Date

0 Issued for Procurement Holden Carroll Erica Poberezny Debbie Adler Youssef 12/22/16 Mohammad-Zadeh

Incorporates: 24590-WTP-EIE-ENG-16-0009

1 Issued for Purchase Erica Holden Carroll Youssef Revised to Conform to Poberezny Mohammad-Zadeh

½fr7--Seller's offering and update Checked v ] Reviewed ~1 materials and material .?~ij!~~,,~~-'.-.~"'1 By: Holden Carroll - hvcarrol ft2.£W'!!.!!.nts

fwi Org Nim• : Ele<:hl•I N• tlonal Inc. Or;,Naf!lll: MET • ;..lo 1 ... ~J ... 01.2011

descriptions. There are no Org Nam•: S.cht•1 Nalion.l, Inc

J>11ced: Ji,#'101.2017 Pia*: Jun01 , 2017

applicable EIEs.

Page 2 of2