Mipa 2K-Plastic-Grundierfiller

Product Information

gb 6/01011

page 1 / 1

Fast drying primer-surfacer with direct adhesion to all plastic materials usually found in automotive industry (PP-EPDM, ABS, PC, ABS-PC, PMMA, PBTP, PA, SAN, PUR, PPO, PVC, GfK, SMC). To be used as adhesion promoter and filler in an unique operation. Wet on wet application is also possible. Recoatable with all 1K- and 2K-paints.

Consumption: 10 - 11 m²/l by 25 µm.

Colour dark grey (approx. RAL 7011)

Mixing ratio 4 : 1 by volume; 5 : 1 by weight

Hardener Mipa 2K-Härter H 10, MS 10, Multi

Thinner

Mipa 2K-Verdünnung normal or Mipa 2K-Verdünnung kurz; Addition: 5 - 10 %

Spraying viscosity 20° C 16 - 18 s 4 mm DIN

Application Spraying pressure Spraying nozzle Spraying operations

Air/Flow jar 3 - 4 bar 1,4 - 1,5 mm 2

HVLP 2,5 - 3 bar (nozzle int. pres.: 0,7 bar)

1,3 - 1,6 mm 2

Pot life 4 - 5 h

Coat thickness / dry film 20 - 30 µm

Curing time /flash off time 10 minutes

Dry recoat time dust dry set to touch full hardeness

Object temp. 20° C

Object temp. 60° C

30 min. 25 - 30 min. 60 - 70 min.

15 min. 10 - 15 min. 20 - 30 min.

Recommandations:

Processing conditions: Do not apply below + 10°C and more than 80 % relative air humidity. By longer storage periods an oil film can occur. In this situation stir the content to restore the initial consistency. Storage life: at least 3 years, if stored in tightly closed original containers.

Please consider the recommendations for plastic coating “Lackieraufbau L7 Kunststofflackierung”

Marking VbF Hazardous materials ordinance Mipa 2K-Plastic-Grundierfiller AI highly inflammable; Xn

This data sheet is for information purpose only. To our knowledge the data provided complies with the latest standard and is based on years of experience in the manufacture of our products. However the data is not binding and without warranty.

MIPA AG · D-84051 Essenbach · Tel. 08703/9220 · Telefax 08703/922100