i6-48 2007 Yamaha - Phazer 07 - 1

2007 YAMAHA

PHAZER MODELSINSTALLATION INSTRUCTIONS

Dynojet Research • 2191 Mendenhall Drive • North Las Vegas, NV 89081 • (800) 992-4993

DOWNLOAD THE POWER COMMANDER SOFTWARE AND LATEST MAPS FROM OUR WEBSITE:WWW.POWERCOMMANDER.COM

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION

PARTS LIST

quantity description

1 Ignition Module1 Programmer

1 Alcohol Swab

2 Velcro Strip1 Installation Guide

i6-48

2007 Yamaha - Phazer 07 - 2

The ignition must be turned OFF before installation.

1 Remove the right side shroud to gain access to the ECU. The ECU is located under the battery.

2 Unfasten the ECU hold down strap.

3 Use the supplied alcohol swab to clean the surfaces of the ECU and the Ignition Module.

4 Mount the Ignition Module on the ECU as shown using the velcro strip provided.

5 Refasten ECU hold down strap over the Ignition Module.

6 Connect the white male connector of the Ignition Module to the female expansion port of the PCIII.

7 Attach the Ignition Module’s ground wire to the negative side of the battery.

Figu

re A

Figu

re B

Figu

re C

ECU hold down strap

Right Side of Machine

refasten hold down strap over Ignition Module

attach ground wire to negative battery

terminal

connect Ignition Module to PCIII

i6-48

2007 Yamaha - Phazer 07 - 3

9 Route Ignition Module wiring harness with the Power Commander (PCIII) wiring harness upward along gas tank.

10 Remove the left side engine shroud and the upper fairing.

11 Disconnect one of the 6-position connectors of the PCIII from the stock wiring connector.

12 Connect the Ignition Module’s 6-position connectors in line with the 6-position connectors from the PCIII and the stock wiring.

13 The Ignition Module is connected to both the PCIII and the stock wiring harness.

Figu

re D

Figu

re E

Figu

re F

route wiring harness upward

along gas tank

Right Side of Machine

wiring from sled

wiring harness from Ignition

Module

wiring harness from PCIII

disconnect PCIII from stock

connector and connect Ignition

Module

Left Side of Machine

i6-48

2007 Yamaha - Phazer 07 - 4

14 Remove the headlight from its bracket.

15 Disconnect the white two-position crank sensor connector located on the left side of the machine beneath the headlight mounting bracket.

16 Connect the Ignition Module’stwo-position connector to the two-position connector from the crank sensor.

17 The crank sensor connects to the Ignition Module through the two-position connectors.

18 Reconnect the headlight and reinstall the engine shrouds. Your installation is complete.

19 Now that the Ignition Module is connected, your PCIII USB is able to use ignition timing maps. For more information on using the software to create custom ignition timing maps, visit www.powercommander.com and download the Power Commander 3 USB Software Guide.

Figu

re G

Figu

re H

Figu

re I

2 position connector from crank sensor

headlight mounting bracket

2-position connector from Ignition Module

2 position connector from crank sensor

wires from Ignition Module

wires from crank sensor

disconnect male and female

connectors of the crank sensor and connect to

the Ignition Module’s male

and female connectors