identifying connector ports and tilt adjusters for andrew ... · identifying connector ports and...
TRANSCRIPT
Identifying Connector Ports and Tilt Adjustersfor Dual/Tri Band Antennas
GENERAL INFORMATIONThe illustrations shown in this bulletin assist in identifying the connector ports and the variable electrical tilt adjusters for multi-port/variable tilt antennas. The antennas are also labeled to provide the most accurate guideline for installation.
Bulletin 639516 • Revision G • June 2009Page 1 of 5
Installation InstructionsAndrew Solutions offers installation training.
Figure 1. DBXCP-4545A-VTM DualPol® Dual Band Antenna, Bottom View.
High Band Tilt Adjuster Low Band Tilt Adjuster
-45° -45° +45°+45°
Low Band PortsHigh
Band Ports
Figure 2. DBXLHC-6565(A/C)-VTM DualPol® Dual Band Antennas, Bottom View.
High Band Tilt Adjuster Low Band Tilt Adjuster
Bulletin 639516 • Revision G • June 2009 • Page 2 of 5Connector Port/Tilt Adjuster Identification Andrew, A CommScope Company
High Band Tilt Adjuster
Low Band Tilt Adjuster
High Band Tilt Adjuster
Low Band Tilt Adjuster
Figure 3. DBXLH-6565(A/B/C/D/EC)-VTM DualPol® Dual Band Antennas, Bottom View.
Figure 4. DBXH2-6565A-VTM DualPol® Dual Band Antennas, Bottom View.
Bulletin 639516 • Revision G • June 2009 • Page 3 of 5Andrew, A CommScope Company Connector Port/Tilt Adjuster Identification
Figure 6. DBXLH-9090C-VTM DualPol® Dual Band Antenna, Bottom View.
1710–2180 MHz
824–960 MHz–45° +45°
–45° +45°
High Band Tilt Adjuster
Low Band Tilt Adjuster
Figure 5. DBXLH-8585(A/B)-VTM DualPol® Dual Band Antennas, Bottom View.
High Band Tilt Adjuster
Low Band Tilt Adjuster
824–960 MHz1710–2180 MHz
Bulletin 639516 • Revision G • June 2009 • Page 4 of 5Connector Port/Tilt Adjuster Identification Andrew, A CommScope Company
Figure 7. TBXLHA-6565(B/C)-VTM DualPol® Tri Band Antennas, Bottom View.
High Band Tilt Adjusters
Low Band Tilt Adjuster
Figure 8. TBXLHB-6565A-VTM DualPol® Tri Band Antenna.
1710–2180 MHz
1710–2180 MHz +45°–45°
–45°+45°
–45°+45°
824–960 MHz
High Band Tilt Adjuster Low Band Tilt Adjuster
Low Band Tilt Adjuster
Bulletin 639516 • Revision G • June 2009 • Page 5 of 5Andrew, A CommScope Company Connector Port/Tilt Adjuster Identification
NOTICEThe installation, maintenance, or removal of an antenna requires qualified, experienced personnel. Andrew installation instructions are written for such installation personnel. Antenna systems should be inspected once a year by qualified personnel to verify proper installation, maintenance, and condition of equipment.
Andrew disclaims any liability or responsibility for the results of improper or unsafe installation practices.
Do not install near power lines. Power lines, telephone lines, and guy wires look the same. Assume any wire or line can electrocute you.
Do not install on a wet or windy day or when lightning or thunder is in the area. Do not use metal ladder.
Wear shoes with rubber soles and heels. Wear protective clothing including a long-sleeved shirt and rubber gloves.
Figure 10. DBXLH-9090B-VTM DualPol® Dual Band Antenna, Bottom View.
1710–2180 MHz
806–960 MHz–45° +45°
–45° +45°
High Band Tilt Adjuster
Low Band Tilt Adjuster
1850–2180 MHz 824–896 MHz–45° +45° –45° +45°
High Band Tilt Adjuster
Low Band Tilt Adjuster
Figure 9. DBXLH-9090A-VTM DualPol® Dual Band Antenna, Bottom View.
OBSOLETE
OBSOLETE
Andrew, A CommScope CompanyCustomer Support CenterNorth America: +1-800-255-1479International: +1-779-435-6500
www.commscope.com/andrew.comVisit our Web site at www.commscope.com or contact your local Andrew representative for more information.© 2009 CommScope, Inc. All rights reserved.Andrew is a trademark of CommScope. All trademarks identified by ® or ™ are registered trademarks or trademarks, respectively, of CommScope. This document is for planning purposes only and is not intended to modify or supplement any specifications or warranties relating to Andrew products or services.