hs-100f series v ibr ation sensor · hs-100f series v ibr ation sensor 2 pin ms connector, low...

2

Upload: others

Post on 29-Apr-2021

4 views

Category:

Documents


0 download

TRANSCRIPT

Page 1: HS-100F Series V ibr ation Sensor · HS-100F Series V ibr ation Sensor 2 Pin MS Connector, Low Speed Accelerometer Technical Perfor mance Envir onmental Mechanical Electrical Noise

Tel: +44(0) 845 680 1957Fax: +44(0) 845 680 1958Email: [email protected]: www.hansfordsensors.com

Operating Temperature RangeSealingMaximum ShockEmissionsImmunity

-55 to 140 ºCIP675000 gEN61000-6-4:2007EN61000-6-2:2005

Case MaterialSensing Element/ConstructionMounting TorqueWeightMaximum Cable lengthMating ConnectorMounting ThreadsOptions

Stainless SteelPZT/Compression8 Nm110 gms (nom)1000 metresH5-AA004See 'How to order' table Integral cable, various connector assemblies,other sensitivities

Mounted Base ResonanceSensitivityFrequency Response

IsolationMeasurement RangeTransverse SensitivityElectrical

22 kHz (nominal)See table1.5 Hz to 10 kHz ±5 %0.2 Hz to 15 kHz ±3 dBBase isolatedSee tableLess than 5%

Typical Applications

Proven use in vibration monitoringfor offline applications using commerciallyavailable data collectors and onlinemonitoring systems in the fields ofConstruction Engineering, Paper and Pulp,Metals Manufacture, Wind Farms andnumerous other applications where lowspeed vibration monitoring is required.

Protecting...Gearboxes, Rolls, Wind Turbines,Rotors and other low speed machinery.

HS-100F Series Vibration Sensor2 Pin MS Connector, Low Speed Accelerometer

Technical Performance

Environmental

Mechanical

Electrical NoiseCurrent RangeBias VoltageSettling TimeOutput ImpedanceCase Isolation

0.1 mg max0.5 mA to 8 mA10 - 12 Volts DC2 seconds200 Ohms max.>10 Ohms at 500 Volts8

Page 2: HS-100F Series V ibr ation Sensor · HS-100F Series V ibr ation Sensor 2 Pin MS Connector, Low Speed Accelerometer Technical Perfor mance Envir onmental Mechanical Electrical Noise

HS-100F Series Vibration Sensor

Dimensions

Frequency Response

Tel: +44(0) 845 680 1957Fax: +44(0) 845 680 1958Email: [email protected]: www.hansfordsensors.com

Ref: HS100F-MS-0111

Mounting of sensor to achieve good repeatable readings.Vibration sensor should be firmly fixed to a flat surface (spotface surface may be needed to be produced and cable anchoredto sensor body.)

TS124 Iss01

Please contact our Sales Office for information on sensor accessories (mounting studs, etc) and multichannel switch boxes.

We reserve the right to alter the specification of this product without prior notice.

2

4

How to order

White

Black