How to recover data from damaged

partition How to recover data from damaged partition? Partition damage is the last thing for user,

however paradoxically, it always happens. Therefore, how to recover lost data from

damaged partition have concerned users the most. MiniTool Solution Ltd. developed

MiniTool Power Data Recover, a green, fast and highly efficient data recovery software, so

as to recover lost data from damaged partition.

--Source from

http://www.powerdatarecovery.com/free-file-recovery-software/how-to-recover-dat

a-from-damaged-partition.html

Partition damage could probably render users considerable losses not only in terms of

time lavished on data, but economically. Partition data loss is likely to bring about tens of

millions of economic loss for user. Therefore, user should attach great attention on data

protection while using computer.

Causes for partition damage generally include following types:

1. Improper operation

2. Virus attack

3. Installation of defective software

Protective tips to slash rate of partition damage:

1. Be careful of operation, never perform any operation unless you have a good

understanding of those operations

2. Be careful of virus prevention, have periodical check and kill of computer virus

3. Purchasing genuine software instead of unknown or pirate ones

4. Using computer correctly, for instance, shutdown system before pulling plug

MiniTool Power Data Recovery is recommended to recover lost data, if partition is

damaged even though user have attached close attention to above tips. Download

MiniTool Power Data Recovery for free atMiniTool Power Data Recovery Download

Center.

To give user a clearer mind of how MiniTool Power Data Recovery recover data from

damaged partition, here I give a demonstration of recovering data from partition G.

Download and install MiniTool Power Data Recovery, then run MiniTool Power Data

Recovery, after that, user may come to this interface.

Unregistered user should check the red zone and click "Launch Power Data Recovery

Free Edition" to enter interface

Choose "Damaged Partition Recovery" module to recover data from damaged partition

Damaged partition G: can' t be opened under Windows, here choose partition G: and click

"Full Scan" to scan partition and decide partition structure type, and scanning result will

be listed as following picture:

Choose partition with highest software advisable values. And click "Show Files" to enter

partition, then original would emerge as follows:

Choose files to be recovered in this interface and then click "Save Files", interface for

setting file saving location would prop up as follow:

Click "Browse..." to set saving location, and then click "OK" to start recovery.

Recovery completes when prompt of successful saving pops up. Thus, data of damaged

partition is recovered.