HANSEN QUEEN BED

MBHANQBAWA

1 Foot Rail

1 Bed Head 2 Side Rail(x2)

3 Middle Rail

4 Center Leg

6 Leg(x4)

A Bolt(x16) B Washer(x16)

5 Slat(x4)

C Bolt Large

F Spanner E Spanner Big

D Hexa Nut

G Allen Key

Step 1: Align the side rails with the Bed Head & Foot rails as② ① shown in the diagram below. Unscrew the hex head bolts and remove them from the brackets.

Step 2: Fit the end rails and side rails together so that the bolt holes overlap. Make sure the labels on each side match as shown in the diagram below. Fit the hex head bolt removed in Step 1 into thehole and tighten it with the spanner E. Repeat this for the other bolt and then repeat the process for the remaining brackets.

Step 3: Align a leg with the bottom of the frame formed in Step 2. ⑥ Make sure the label on the leg matches the label on the side as shown in the diagram below.Fit a washer B to a bolt A and then insert the bolt into a hole. Tighten the bolt with the Allen key G. Repeat this for the remaining holes and then repeat the process for the remaining legs.

Step 4: Fit the middle legs to the middle rail and make sure the ④ ③ holes overlap. Insert the long bolt C into the hole and make sureit protrudes from the other side. Attach the hex nut D to the bolt and tighten it with the spanner F.

Step 5: Place the structure formed in Step 4 upon the slots of the end rails. Once placed securely, middle legs should be 2-3mm o the ground.

Step 6: Place the slat sets ⑤ on the bed frame. Make sure the Flat End sits close to the bed ends while Protruding End sits in the centre.

Step 7: Place the bed in its desired location and enjoy your new Bed !

NOTES

NEED MORE INFORMATION?

We hope that this user guide has given you

the assistance needed for a simple set-up.

For any additional assistance you may require,

head online to help.mattblatt.com.au

MJ\TT BLATT

Page 1Page 2Page 3Page 4Page 5Page 6Page 7Page 8Page 9Page 10Page 11Page 12Blank Pagenotes.pdfNOTES