dx200d
DESCRIPTION
Dx200dTRANSCRIPT
DX200D INSTALLATION AND PROGRAMMING
WIRING
S1
S2
5 4 3 2 1
120 VAC Hot120 VAC Neutral
Motor Starter for Dryerwith unused NO Contacts built in
For timer to start counting, a dry contact closureis required between terminals 3 and 5.This closure may be either momentary or constant.
Wiring Connections
1 120VAC Hot2 120VAC Neutral3 Timer Start4 No Connection5 Timer Start
DO NOT APPLY VOLTAGE TO TERMINAL 3 OR 5
Other timer start connections
Dryer turn on signal HotDryer turn on signal Neutral
Relay
Coil
Common
NO Contacts
5 4 3 2 1
DX 200 D
PROGRAMMING
Digits are individually set as follows:S1 Adjusts seconds individually (right digit)
S2 Adjusts seconds by 10's (left digit)Example: To set display to show 90 seconds: Set S2 to '9' Set S1 to'0'
5 4 3 2 1
DX 200 D
120 Volt Hot
120 Volt Neutral
120 Volts Applied when Dryer starts
Timer will be dark when not in use.When Dryer starts timer will light up andstart counting down.
Jumper3 & 5
DIXMOR ENTERPRISES5755 S. GALLUP ST
LITTLETON CO 80120303-794-0597