Download - Cura 3 Slicer Quick Start Guide · Start Cura IMADE3D Edition. If you see this splash screen, you're good to go into Initial Setup. If you see anything else, continue with Troubleshooting

Cura 3 Slicer Quick Start GuideYou want to start slicing and printing your 3D models of Your choosing as fast as you can.

Herein lies the magic.

Cura 3 Slicer Quick Start Guide

© 2018 docs.imade3d.com/ of 4

INTRODUCTION

You want to start slicing and printing your 3D models of Your choosing as fast as you can. Herein liesthe magic.



Step 1 — Download and Install Cura

Don't have Cura yet? Head over to our CuraDownload and Installation instructions.

Step 2 — Cura Quick Start Guide

Our Cura Quick Start Guide will get youstarted.



https://go.imade3d.com/cura-download

http://go.imade3d.com/cura-quick-start

This document was last generated on 2018-08-24 06:55:36 AM.

Step 3 — Discovery Place Workbook

Here's a Cura 3 workbook from Joel Bonaserafrom Discovery Place in Charlotte, NC.

This workbook has simple interactive tasks toget you going in Cura. Joel uses it in his F2Fworkshops.



https://docs.google.com/document/d/1xDVU5cZgVI9oa82RxhCgZqr5nJ_jqdlWDAWMJDjpYL4/edit?usp=sharing

Download - Cura 3 Slicer Quick Start Guide · Start Cura IMADE3D Edition. If you see this splash screen, you're good to go into Initial Setup. If you see anything else, continue with Troubleshooting

Top Related