cura 3 slicer quick start guide · start cura imade3d edition. if you see this splash screen,...

4
Cura 3 Slicer Quick Start Guide You want to start slicing and printing your 3D models of Your choosing as fast as you can. Herein lies the magic. Cura 3 Slicer Quick Start Guide © 2018 docs.imade3d.com/ Page 1 of 4

Upload: vunhan

Post on 26-Jan-2019

222 views

Category:

Documents


0 download

TRANSCRIPT

Page 1: Cura 3 Slicer Quick Start Guide · Start Cura IMADE3D Edition. If you see this splash screen, you're good to go into Initial Setup. If you see anything else, continue with Troubleshooting

Cura 3 Slicer Quick Start GuideYou want to start slicing and printing your 3D models of Your choosing as fast as you can.

Herein lies the magic.

Cura 3 Slicer Quick Start Guide

© 2018 docs.imade3d.com/ Page 1 of 4

Page 2: Cura 3 Slicer Quick Start Guide · Start Cura IMADE3D Edition. If you see this splash screen, you're good to go into Initial Setup. If you see anything else, continue with Troubleshooting

INTRODUCTION

You want to start slicing and printing your 3D models of Your choosing as fast as you can. Herein liesthe magic.

Cura 3 Slicer Quick Start Guide

© 2018 docs.imade3d.com/ Page 2 of 4

Page 3: Cura 3 Slicer Quick Start Guide · Start Cura IMADE3D Edition. If you see this splash screen, you're good to go into Initial Setup. If you see anything else, continue with Troubleshooting

Step 1 — Download and Install Cura

Don't have Cura yet? Head over to our CuraDownload and Installation instructions.

Step 2 — Cura Quick Start Guide

Our Cura Quick Start Guide will get youstarted.

Cura 3 Slicer Quick Start Guide

© 2018 docs.imade3d.com/ Page 3 of 4

Page 4: Cura 3 Slicer Quick Start Guide · Start Cura IMADE3D Edition. If you see this splash screen, you're good to go into Initial Setup. If you see anything else, continue with Troubleshooting

This document was last generated on 2018-08-24 06:55:36 AM.

Step 3 — Discovery Place Workbook

Here's a Cura 3 workbook from Joel Bonaserafrom Discovery Place in Charlotte, NC.

This workbook has simple interactive tasks toget you going in Cura. Joel uses it in his F2Fworkshops.

Cura 3 Slicer Quick Start Guide

© 2018 docs.imade3d.com/ Page 4 of 4