1. Clean damaged surface with a damp clean cloth.Slide one stick of glue into the glue gun and pre-heat hot glue gun for 5 minutes.

2. Match the glue pad with the size of dent. Largest dents require the large pad. (Note: The larger the pad the greater the pulling power.)

3. Apply a generous amount of hot glue from the hot glue gun on the selected pad covering the entire surface of the pad. Be sure all 4 holes are covered.

4. Immediately place pad in the center of the dent and hold until it sticks by itself.

5. Let glue dry approximately 8 minutes. The glue should be fi rm. We recommend you do not let glue dry longer than 10 minutes

6. Place the stem of the pad through the hole in the Dent Gone pulling bridge

7. Screw on the knob. Tighten the knob until the pad POPS off.

8. Repeat process until dent is level with surface.

9. If the metal is pulled and created a high spot use the following procedure. First use your thumb and massage the high area until it is even with the surface. If this does not lower it enough then use the knock down tool and apply light pressure over the high spot until it is even. You may need to repeat this several times. [Note: push lightly several times rather than pushing hard.)

10. In the unlikely event that glue stays on metal surface carefully peel off by hand or use white spirits to remove any excess glue remaining.

DENTGONE Diy Dent/ding Repair KitStep-by-step Instructions

Click images for video

WARNING: DO NOT ALLOW FOR GLUE TO HARDEN FOR ANY LONGER THAN 10 MINUTES.

Please contact the Service Centre on 1300 777 137.