ccvp_lab_equipment_recommendation
TRANSCRIPT
-
8/7/2019 CCVP_Lab_Equipment_Recommendation
1/2
CCVP Lab Equipment Recommendation
by
Kevin Wallace
If you wish to build a home lab to practice CCVP concepts (in addition to Voice CCNA concepts), the
following equipment list is a minimum configuration that I recommend. I say minimum, because you
could optionally add on an additional branch office that connects into the Public Switched Telephone
Network (PSTN) via an E1 circuit.
-
8/7/2019 CCVP_Lab_Equipment_Recommendation
2/2
Hardware Part Number Description Quantity
Cisco WS-C3750-24TS 24-Port Cisco Catalyst 3750 Switch 1
PVDM2-8 Packet Voice DSP Module version 2 - 8 3
PVDM2-16 Packet Voice DSP Module version 2 - 16 3
VWIC-1MFT-T1 1-Port T1 Voice WAN Interface Card 2
C2811 512/256 Cisco 2811 ISR Router with 512 MB of DRAM and 256 MB of Flash 3
HWIC-4ESW 4-Port Ethernet Switch Module 1
WIC-1T 2-Port DB-60 Serial Interface Card 2
AIM2-CUE Cisco Unity Express AIM Module Version 2 1
VWIC-2MFT-T1 2-Port T1 Voice WAN Interface Card 1
Serial 2T 2-Port Smart Serial WAN Interface Card 1
CP-7941G Cisco 7941G IP Phone 2
CP-7960G Cisco 7960G IP Phone 3
Cables
1.5' Smart Serial to DB-60 Serial Cable 2
3' Crossover Ethernet Cat 5e Cable 1
3' Ethernet Cat 5e Cable 6
T1 Crossover Cable 2
Software
Vmware ESXi (virtual server software to support the Cisco
Unified Communications servers)
Cisco Unified Communications Manager, Cisco Unity Connection,
Unified Contact Center Express, and Unified Presence Server version 6.x,
7.x, or 8.x
Cisco IOS 12.4(21)T for Cisco 2811 Routers (IP Voice Feature Set)
OR
Cisco IOS 15.1(1)T1 for Cisco 281 Routers (IP Voice Feature Set)
Cisco IOS 12.2(25r)SEC for Cisco 3750 Catalyst Switch
Server Specs.
12 GB of RAM
1 TB HD
The recommended topology contains three Cisco 2811 routers: one for the HQ gateway, one for the
Branch Office gateway, and one for the PSTN/Frame Relay clouds.
The Cisco IOS 12.4(21)T software can be used on the Cisco 2811 routers if you wish to support CiscoUnified Communications Manager Express version 7.
The Cisco IOS 15.1(1)T1 software can be used on the Cisco 2811 routers if you wish to support Cisco
Unified Communications Manager Express version 8.
Each router contains one PVDM2-8 and one PVDM2-16, which are inserted into the router
motherboard.