bridge cutting machine model hto-garbi+ · the bridge cutting machine hto-garbi was specifically...
TRANSCRIPT
This is a general information brochure. Pictures and characteristics of the machines are illustrative and they could change according to an specific order.
BRIDGE CUTTING MACHINE
MODEL HTO-GARBI+
GENERAL DESCRIPTION The bridge cutting machine HTO-GARBI was specifically designed for those
workshops in starting period or for those who, leaving behind arm cutters, want to
increase production rates keeping costs.
This machine can cut whole stone slabs or smaller pieces of marble, granite, natural
stone, sandstone, etc.
Thanks to its working system you can easily obtain paving, kitchen and bath
countertops, slides, skirting, etc.
This is a general information brochure. Pictures and characteristics of the machines are illustrative and they could change according to an specific order.
STANDARD TECHNICAL CHARACTERISTICS MOTORS
Disk motor power 7,5 Kw - 10Cv. Auxiliary motor power (long, vert, trans) 2 Kw aprox.
HEAD
Inclination of the disk. Manual
Extreme angles of inclination. Between 0º y 45º Diameter of the disk. 350-500 mm
AXIS STROKES AND MOVEMENTS
Vertical stroke of the disk. 150 mm
Vertical movement. Motorized
Length stroke of the disk (with D.350mm). 3300 mm
Length movement. Motorized + viewer
Transversal stroke of the disk. 3500 mm Transversal movement. Motorized
TABLE
Tilting and manual turning table, blocking system at 0º, 45º, 90º, 135º, 180º and 270º by pushbutton. Position light provided.
Table dimensions 3000X1600 mm
AUTOMATISM
Electronics regulation of speed for strokes.
Automatic system for the opening and locking device of the water
Automatism of cut by temporized steps. Transversal stroke with programmer of sizes.
STRUCTURE AND COMPONENTS
Laser pointer of 10 mV
Protected bridge guides Protected and oil bathed carriage guides
TECHNICAL DATAS
Total required electrical power 9 Kw aprox
Water consumption (with disk of 350 mm) . 15 l/min
Approximate net weight of the machine and accessories. 3600 Kg.
Maximum dimensions 5116x4664x2230mm
Minimum air pressure. 6 bars
Three phase power supply + neuter: 400 v. 50 Hz.
This is a general information brochure. Pictures and characteristics of the machines are illustrative and they could change according to an specific order.
HTO-GARBI+ STANDARD FEATURES
This is a general information brochure. Pictures and characteristics of the machines are illustrative and they could change according to an specific order.
TECHNICAL DESCRIPTION
Machine structure is basically composed by a bridge and a table where the material is
placed.
The strong bridge is placed on the top of two concrete or metal walls. The table is
fixed on the floor between the walls.
The carriage is moved along the bridge. It can be tilted and blocked to any angle
between 0º and 45º, so bevelled cuts can be easily done. Vertical movement is also
motorized.
The table can tilt and it manually turns at 360º. It has high precision locks to fix it
position at the most useful angles, so square and non square cuts can be easily
done.
On the control box there is a touch screen, where the worker can control
measurements, motor consumption and can operate the automatic cutting programs.