AXAUNO BACK TO WALL PAN

SPECIFICATIONSRecommended use Domestic, Hotel and Commercial

Colour availability White

Rim configuration Open rim

Set out S Trap: 95mm

P Trap: 180mm fixed

Pan fixing Fixed to floor

Seat Matching top fix Soft Close Quick Release seat supplied with suite

Material Vitreous china

Weight Pan: 25kg

CLEANING RECOMMENDATIONSWe recommend the use of soapy water or approved bathroom cleaners.

This bathroom product should not be cleaned with abrasive materials.

Damage caused by any improper treatment is not covered by the product warranty - Refer to Warranty Conditions.

To see the complete Axa range go to www.reece.com.au/bathrooms

520

360390

20095

420180

350

180

99

page 1 of 2

Disclaimer: Products in this specification manual must by regulation be installed by licensed and registered trade people. The manufacturer/distributor reserves the right to vary specifications or delete models from their range without prior notification. Dimensions are nominal measurements only. Dimensions and set-outs listed are correct at time of publication however the manufacturer/distributor takes no responsibility for printing errors.

Tech Page Version 5

TM

WMKA21243 AS 1172.1

Dimensions are nominal measurements only

The more stars the more water efficient

WATER RATINGwww.waterrating.gov.au

In accordance with AS/NZS 6400

Licence No. 0437AXA ONE SrL

4.5 L per full flush / 3 L per half flush

3.3 litres average flush

AXAUNO BACK TO WALL PAN

INSTALLATION INSTRUCTIONS

Note

All measurements for roughing in should be taken from finished wall/floor. Dimensions shown are nominal measurements only.

1. Rough in positions of water inlet and waste outlet.

2. Mark out and drill floor fixing brackets into position (140mm apart, 200mm from finished wall) and mark out and prepare plate, rod and plastic bend if installing the waste into the floor via a pan collar.

3. Fix the pan bend connector back to the wall using the rod and bracket.

4. Align and push pan back to wall, connecting pan spigot into waste bend and pan inlet into flush pipe and keeseal.

5. Check pan is level.

6. Fix pan by using the fixing screws through the fixing holes into the floor fixing brackets.

7. Flush pan to check connections for leaks.

8. Apply flexible sealant around base and rear of pan to seal to wall and floor.

he

m

e

250mm

200mm14

0mm

175mm

m

4-6 P-Trap installation

350

inlet

outlet

175

Levelling

S-Trap setup P-Trap setup

Fixing

SILICONE

Pan collar

140

page 2 of 2

Plumbers, please ensure a copy of the installation instructions is left with the end user for future reference