appendix 1 doe-pc iv input and output -...
TRANSCRIPT
367
APPENDIX 1
DOE-PC IV INPUT AND OUTPUT
Input - DOE-PC IV program requires the experimental values at different
trial runs as given in design matrix and these values has to be entered into the
base analysis array as shown below.
368
Output
369
APPENDIX 2
MINITAB 16 STATISTICAL SOFTWARE
INPUT AND OUTPUT
Input - Minitab 16program requires the experimental values at different trial
runs as given in design matrix and these values has to be entered into the base
analysis array as shown below.
Output
370
APPENDIX 3
DESIGN EXPERT-7 SOFTWARE -3D SURFACE PLOT
Design expert-7 software sample output obtained for cross feed and
thrust force is as shown below.
The interaction effect of cutting speed and cutting feed 3D surface
plot for cross feed force.
The interaction effect of cutting speed and cutting feed 3D surface
plot for Thrust force.
371
APPENDIX 4
OUTPUT OF SURFACE ROUGHNESS MEASUREMENT
372
APPENDIX 5
CUTTING FORCE MEASUREMENT
Output
373
APPENDIX 6
FFT OUTPUT
Vibration amplitude and spectrum