an approach to build nhp small cell infrastructure on end to end ... - netco...

• Neither the information nor any opinion expressed in this presentation constitutes an offer, or invitation to make an offer, or to buy any security issued by the company. This presentation contains predictions, estimates or other information regarding the Company's operations which are forward looking in nature. While these forward looking statements represent our best current judgment on what the future holds, they are subject to risks and uncertainties that could cause actual results to differ materially and may involve risk and uncertainty. This presentation is prepared for general purposes only and does not have any regard to the specific investment objectives, financial situation and particular needs of any specific person. No liability for any loss will arise with the company as a result of the action taken on the basis of information contained herein.

Safe Harbor

An approach to Build

NHP Small Cell Infrastructure On End to End

Managed Services Model

www.netcoconverge.com

Need of the hour

Major scope NCPL :

• Site (Building) acquisition services, acquiring the rights to deploy on site.

• Radio coverage and capacity plan

• Backhaul Management

• Site survey and installation planning for deploying the small cells solution

• Physical deployment of SC , Aggregation switch, Edge switch, AP-Controller etc and all cabling work as per the site survey

• Commissioning & Integration

• Supply of Materials/products indicated in the BOM as required

• Construction/Civil works as required

• Managed services of infrastructure at site

Operator :

• Planning guidelines ,issue of Active Hardware –APs and Sw & Controllers,parameter ,radio Tools and optimization support and end customer services.

• Small cell can be provisioned by NCPL with spectrum from spectrum owner

Small Cells

For SME

&

Residential

NCPL Small Cell Delivery Model

NCPL

Backhaul

Management

Real

Estate

Partner

Complete Lifecycle Support

(Plan ,Deploy, Maintain, Upgrade)

Small Cell

Controller

s/GW

SC/APs Internet Cloud /

Operators

/NCPL

Network

The End to End Small Cell Delivery model

Telecom

Service

Providers

http://nerdsinstereo.com/rambler/wp-content/uploads/2011/04/Cloud.png

Acquisition

Key Aspects are agreements with building owner including:

• Negotiate financial terms and facilitate commercial lease contract closure

• Sharing building infrastructure for AP installations - Telecom rooms, cable routes, risers, electrical closets, a/c power etc

• Feasibility for IT infrastructure sharing for backhaul

• Agree on timelines and working hours for deployments

• Security & access clearances for deployment teams

• Access to building floor layout and cabling drawings

• Clearance for AP mounting in public areas of the building

• Camouflaging needs if any

• Product / material storage facilities - on-site

• Identify any ‘no go’ areas for AP installation

• Any other special needs

Design Scope

A) Preparation and information gathering Collect information about the building:

• Floors layouts.

• Information on aesthetic constraints.

• Any cable crossing constraints if any

• Customer requirements in terms of coverage and traffic.

• Exact description of strategic places to be covered B) Site survey:

• better understanding of the building layouts in order to identify possible places for Small Cells positions and to perform indoor digital measurements.

• Customer interaction and finalizing there options for Small cells location space and cabling route.

• Location for mounting switches and controllers, Power management , Cat 6 cabling /fiber backbone route etc

c) Design Scope

• Use IB Wave Planning tool for designing of small cell network

• Use the designing criteria and rules provided by the Operators .

• Submit and fine tuning of final design-An interactive process

• BOQ outcome: number of APs per floor, CAT 6 cable length, Fiber , POE etc

• Using a defined set of rules which are pre-agreed between all parties to plan the radio coverage & capacity requirements for the site based upon customer requirements.

• Providing a report showing covered areas in picture and tabulated format, location of AP’s and other equipment & cables Full BOM as an output of a proper radio planning exercise. Architecture diagrams Backhaul capacity dimensioning in alignment with agreed rules

D) Simulation : • Use Transmitter at possible small cell location and conduct signal measurement in case of

floor area is large and complex

Deployment

• Follow the guidelines by operators for AP SC per Floor

• The AP to be wired to the floor level switch located in the wiring closet through CAT6 cabling

• The AP will get the power through PoE++ installed next to the floor level switch

• Average CAT6 cable length per AP/ SC < 60 m

•

Typical AP connection

To Edge switch

AP

Agg. Switch and PoE++ injector

AP & Backhaul BOM

Description Per Floor Qty Total for 2 (G+1)floors

AP 3 6 Aggregation switch ) 0 0

PoE++ injector ( ) 1 1

AP-Zone Controller 1 Edge Switch ( 1

Ancillary BOM

Description Per Floor Qty Total for 2

floors

Plenum rated CAT6 cable (m) 180 360 Ethernet face plate 3 6 CAT6 Jumper cable (3 m) 3 6 Wall mount cabinet for Switch & PoE 0 0 Patch Panel for CAT6 cable 0 0 CAT6 Jumper cable (0.5m) between Switch & PoE 8 8 Fiber cable between Agg switch to Edge switch (average 40 m length) 0 0

19" rack (small) for Edge router - 1 Patch Panel for CAT6 cable - 1 AC power cable & grounding cable 5 5

shared passive infra for multi services

FLR Unit-1 Unit-2 Unit-3 Unit-4

P1

P2

P3

P4

5Fixed lineVoice

data service18 19

2 5 6 7

3 9 10 11

1 1 2 3

SHAFT

4

12

8

27 28

6 21 22Fixed lineVoice

data service24

32

20


data service16

7 25 26

8 29 30 31

40

9 33 34 35 36

10 37Fixed lineVoice

data service39

48


data service44

12 45 46 47

13 49 50 51 52

TOWER-A : FIBER DISTRIBUTION PLAN

192 Fiber FMS (GRNL)

5 Spare Fibers

12 F FMS/ SWITCH/ POWER RACK

Dark Fiber

(96F) by GRNL

CAT5/6/7

Cable/fiber

192 Fiber FMS (GRNL)

service providers

SWITCH/CORE/Tx/ NW

EXISTING TELECOM/IBS

ROOM

EXISTING

TELECOM/IBS

ROOM













Deployment…….contd

• Backbone cabling

Typical layout

Switch + POE++

FZ Controller

Backhaul cabling: •Horizontal runs in a floor is CAT6/7a/CPRI and power cable •Vertical runs between switch’s is fiber optic

Deployment tasks: 1. Availability of all installation materials at the installation site 2. Site preparations for installation work 3. Install the SC per floor as per the survey report 4. Install the Wall mount cabinet for switch & PoE in every floor 5. Install the Switch, PoE++ & Patch Panel in the wall mount

cabinet 6. Connect all jSwitch cables between Switch, PoE & Patch Panel 7. Install the CAT6 cable between Patch Panel and face plate near

Small Cell including the installation of faceplate. 8. Connect the Switch cable from face plate to Small Cell 9. Install all cablings, patch panels as per site survey report. 10. Perform power on and perform basic tests 11. Install the19” rack for Controller and Edge switch 12. Install the Edge switch and SC-Controller 13. Reporting the installation progress 14. Prepare the installation part of the As-Built documentation

Commissioning and Integration

Commission and integrate the system into operators operational systems & check for basic operation

1. To confirm with operations team equipment is ready for integration

2. To load, or monitor the remote loading of configuration data

3. To support integration activities under the direction of the operations team

4. Perform walk test to check operation of cells and intra and inter cell handovers using test mobiles

5. Update & complete handover pack for Operators records

Thank You

Contact us @

Email ID: [email protected]

Tel: +91-22-27620090

Netco Converge Pvt Limited

“ Global Vision” ES-2 , MIDC, TTC Industrial Estate,

Mahape Navi Mumbai 400710 India

CIN No:U45400MH2015PTC267614

www.netcoconverge.com

an approach to build nhp small cell infrastructure on end to end ... - netco...

Documents