yamaha wire conrad wire wires / coulours / connection ... · the superseal waterproofed connection...

Front lever brake switch from the 3YA with ABS

Changing the front brake pump to a Fazer 600 means to modify the brake switch too, then the OEM switchdoesn't fit anymore and the Fazer 600 switch has only two wires instead of three as needed by the ABS.

As schleife (from the german FJ forum) told, the switch from Conrad is a usable alternative and I choosed it.

Connect Yamaha wire Conrad wire Wires / coulours / connection Yamaha switchbrown brown earthbrown/blue blue not braking Braking / switch on Not braking / switch offyellow black brake brown/blue

brown

yellowBrake switch Conrad

Wires / coulours / connection Conrad switch

Braking / switch on Not braking / switch offblue

brown

black

An easy and clean way to fix the switch.aluminium-plate

40mm

blue

brown

black

6mm

13mm

10.5mm

6mm

12mm

14mm

ø 3mm

M4

15mmø 3mm

2mm

23.5mm

M4

Made by Efejota

The SuperSeal waterproofed connectionon the way to the OEM connection, becausethe Conrad wires aren't enough long.

A positive additional point is the bigger room to the fork.As you can see it is already 15mm higher and has stillroom to go further.

connection under the rightair scope

Link to the switch at Conradhttps://www.conrad.de/de/mikroschalter-24-vdc-2-a-1-x-einein-marquardt-10580653-ip67-tastend-1-st-702667.html

Made by Efejota