yamaha wire conrad wire wires / coulours / connection ... · the superseal waterproofed connection...
TRANSCRIPT
Front lever brake switch from the 3YA with ABS
Changing the front brake pump to a Fazer 600 means to modify the brake switch too, then the OEM switchdoesn't fit anymore and the Fazer 600 switch has only two wires instead of three as needed by the ABS.
As schleife (from the german FJ forum) told, the switch from Conrad is a usable alternative and I choosed it.
Connect Yamaha wire Conrad wire Wires / coulours / connection Yamaha switchbrown brown earthbrown/blue blue not braking Braking / switch on Not braking / switch offyellow black brake brown/blue
brown
yellowBrake switch Conrad
Wires / coulours / connection Conrad switch
Braking / switch on Not braking / switch offblue
brown
black
An easy and clean way to fix the switch.aluminium-plate
40mm
blue
brown
black
6mm
13mm
10.5mm
6mm
12mm
14mm
ø 3mm
M4
15mmø 3mm
2mm
23.5mm
M4
Made by Efejota
The SuperSeal waterproofed connectionon the way to the OEM connection, becausethe Conrad wires aren't enough long.
A positive additional point is the bigger room to the fork.As you can see it is already 15mm higher and has stillroom to go further.
connection under the rightair scope
Link to the switch at Conradhttps://www.conrad.de/de/mikroschalter-24-vdc-2-a-1-x-einein-marquardt-10580653-ip67-tastend-1-st-702667.html
Made by Efejota